ICP iSun Instructions

Important Notes Important Notes
• ALWAYS connect the power cable and adapters first, then your electronic device last. Otherwise it may cause a short circuit.
• DO NOT attempt to recharge NON-RECHARGEABLE alkaline batteries.
• When using iSun™ in your vehicle, make sure your vehicle's temperature is within the allowable specified range (see General Specifications).
Instructions
Solar panels Suction cup
FIG.1
Male
plug
A
Suction cup Test LED indicator
FIG.2
1
2
Accessories Included
Female socket adapter cable
1
2 Suction cups
3 Power cable
2.5 mm male adapter
4
5 3.5 mm male adapter
5.5 x 2.5 mm female adapter
6
5.5 x 2.1 mm female adapter
7
5.0 x 2.1 mm female adapter
8
4.0 x 1.7 mm female adapter
9
3.5 x 1.4 mm female adapter
10
FIG. 3
*
Instructions
TM
IMPORTANT: Please read the following instructions before operating your iSun™ unit
Step 1: TESTING
Open the iSun™ by pushing on the small black latch at the front of the unit. Place the iSun™ in
full sunshine and test it by pressing the yellow test button to the right of the latch. The green
LED will light up indicating sufficient sunlight is present and your unit is working properly.
Step 2: POSITIONING
Always select a location where your iSun™ will get the maximum sunshine. Tilt the iSun™
towards the sun for best performance.
Step 3: WINDOW MOUNTING
Female
Your iSun™ comes with 2 suction cups
socket
window. Before mounting to a window, secure the suction cups in the holes on the inside of
B
the frame (see FIG. 1).
Step 4: CHOOSING 6V/12V
On the back of the iSun™ you will find a
Test button
6V/12V switch. Select the 6V position when
connecting to electronics requiring 6V or
less (i.e. mp3 and minidisc players, digital
cameras, and electronic games). Select the 12V
4 - 10
position when connecting to electronics requiring
12V or when using the female socket adapter cable
specifications before using your iSun™.
3
Proper Adapter Connection
Start by connecting the power
cable
of the iSun™, then connect
B
the adapter
electronic's power jack to the power cable .
Connect the adapter to your electronic device.
VERY IMPORTANT: Most iSun™ users in North America must match the adapters
the power cable
Conversely, most iSun™ users in Europe must match adapters to the power cable + to -
(positive to negative) if their electronic device displays this symbol
will occur if the incorrect polarity is used.
Cellular Phone Connection
In the 6V position (recommended for faster charging, see FIG. 4), the female socket adapter
cable
included, see FIG. 3) into the female socket adapter cable. Plug your male cigarette adapter
plug into your cell phone.
All your connections should be made correctly before plugging in your cell phone. If your cell
phone does not indicate that it is charging while in the 6V position, switch to the 12V position.
Connect to Electronic Device
to the female socket
3
that best fits your
4 - 10
+ to + (positive to positive) if their electronic device displays the symbol
3
. This symbol is usually found next to the power output of the electronic device.
plugs into the female socket
1
. This allows you to mount your iSun™ directly to a
2
6V / 12V switch
. Always check your electronic's
1
4 - 10
Adapter Power cable
. Then plug the male cigarette adapter plug (*not
B
FIG.4 - BACK VIEW
FIG.5
Connect to iSun™ female
B
socket
®
3
to
4 - 10
. No charging