Subscribe to Our Youtube Channel
Related Manuals for Flo Fab S Series
Summary of Contents for Flo Fab S Series
- Page 1 SINCE 1981 Heat Exchangers Series S & W Operation, Maintenance & Installation Manual www.flofab.com 001-iom-2017-hesw...
- Page 2 INDEX Application Operating Principle III. Construction (Features & Material) Operating Parameters & Selection of Heat Exchangers Installation Startup/Shutdown VII. Operation VIII. Maintenance Storage & Transportation Warranty Terms Warranty Claims Form XII. Sales & Service...
-
Page 3: Operating Principle
I.O.M - HEAT EXCHANGERS : SHELL & TUBE, S/W SINCE 1981 I. APPLICATION U-tube heat exchangers are designed for a wide range of liquid to liquid and steam to liquid ap- plications. We offer products of the highest quality and reliability to satisfy your most rigorous demands. - Page 4 I.O.M - HEAT EXCHANGERS : SHELL & TUBE, S/W SINCE 1981 III. CONSTRUCTION FEATURES Available in 2 or 4 pass construction, our products are enhanced with stainless steel tubes in the standard construction, rugged cast iron or steel heads, and unique coil and baffle arrange- ments to optimize the thermal performance of the heat exchangers.
-
Page 5: Installation
I.O.M - HEAT EXCHANGERS : SHELL & TUBE, S/W SINCE 1981 IV. OPERATING PARAMETERS & SELECTION OF HEAT Standard maximum working parameters of the heat exchangers are as follows: Regardless of the application, proper sizing of a heat exchanger is extremely important in ob- taining the desired thermal performance from the unit. -
Page 6: Operation
I.O.M - HEAT EXCHANGERS : SHELL & TUBE, S/W SINCE 1981 The S and W-models are designed for horizontal installation. If space is a constraint and vertical installation is required, please inform the sales office. Before piping up, inspect all openings in the heat exchanger for foreign material. Remove all plugs and shipping covers immediately prior to installation. -
Page 7: Maintenance
I.O.M - HEAT EXCHANGERS : SHELL & TUBE, S/W SINCE 1981 Under no circumstances should there be pulsating of fluids, as this causes vibrations that could damage the structural integrity of the heat exchanger. The system should be designed to prevent the unit from encountering pressure shocks and rapid temperature changes. -
Page 8: Storage And Transportation
I.O.M - HEAT EXCHANGERS : SHELL & TUBE, S/W SINCE 1981 LEAKS To locate ruptured or corroded tubes or leaking joints between tubes and tubesheet, the fol- lowing procedure is recommended: Drain the heat exchanger completely of any fluid or moisture. Pressurize the shell side of the unit with fluid (e.g. - Page 9 We are proud supplier for the following completed and on going projects : Rutgers University Bella Vista Ltd., Apartments 26 Torbay Road. St. 604 Bartholomew Road John’s, NL. A2A 2G4 Piscataway, NJ 08854 Cité du Nouveau Monde Le Murray 64 rue St-Paul Ouest, 1169, Rue Ottawa, Montreal, QC, H2Y 1Y8 Montréal, QC H3C 1S6...
Need help?
Do you have a question about the S Series and is the answer not in the manual?
Questions and answers