Table of Contents
Advertisement
DV-NC65H/S
DV-NC70H
6-3. REPLACEMENT OF MAIN PARTS
<Take out disk>
1. Remove the mechanism with angle from the set. (refer to 33 on page 130. Remove K , M , N )
2. It is in such cases as the thin driver, and it is pushed in slowly, and a tray is drawn in the arrow direction the Slide Rack on the
left of the base chassis.
3. Take out disk.
<Disassembling and assembling the mechanism chassis>
1. After setting the mechanism chassis to the angle state, ground it to prevent the electrostatic discharge damage of the pickup.
2. Remove the DVD Shield (lower) 40 (refer to the illustration on page 130).
3. Remove P , Q from the DVD Main PWB Unit 27 . (Pickup Relay FFC 58 isn't removed.) (refer to the illustration on page 130)
4. Remove screws fixing the base chassis (located at the back right and at front left when facing the set).
5. With the Pickup FFC connected, turn over the base chassis and short (solder) two short lands on the pickup interface PWB in
order to prevent the electrostatic discharge damage of the pickup.
6. Remove the Pickup FFC from the Main PWB.
7. Remove the Pickup FFC from the Pickup Interface PWB.
8. Remove the Traverse Fixing Screws to remove the Traverse Chassis ass'y.
Note: After assembling and wiring, remove the solder joint of the short land. If short-circuited, a disk is not played back.
<Replacing the Pickup and the Spindle Motor>
Since the Pickup optical axis and turntable inclination of DVD are adjusted with higher accuracy, make a replacement as a
mechanism service chassis ass'y.
Pickup FFC
Sled Motor Lead Wire
Loading Motor Lead Wire
Pickup Interface PWB
18
Front Side
Traverse Fixing Screw
Pickup FFC
Short Land
Advertisement
Table of Contents
