Taking Into Operation; Repair; Maintenance & Cleaning - SCE Enviro-Therm -TE680B24VSS User Manual

SAGINAW CONTROL & ENGINEERING • A/C USER MANUAL
B
Heat load to be dissipated from enclosure should not exceed specific cooling output of the unit at any condition. While
selecting a cooling unit always cater for a safety margin of at least 15% extra cooling output.
The Peltier - elements should be controlled by a suitable thermostat. We recommend the SCE-TEMEVDC Thermostat.
In case of fault Contact Saginaw Control & Engineering - Customer service department at 1-800-234-6871 or E-Mail
Customerservice@saginawcontrol.com
All Peltier units are virtually maintenance-free with no filters that need to be cleaned or replaced. Check the ambient heat
sinks from time to time. In case they are dirty proceed as following:
• Disconnect the enclosure from the mains.
• Clean the heat sink profile as required by blowing it out with compressed air.
• In cases of extreme pollution wet cleaning is required.
Should a wet cleaning be necessary proceed as following:
• Disconnect the whole plant from the mains.
• Remove the unit from the cabinet.
• Ensure that the seals are not damaged.
• Wash the heat sink with an environmentally safe cleaning fluid.
Disposal
Dispose of cooling unit and used parts with due regard for the environment and in accordance with environmental laws and
regulations.

13. Taking Into Operation

The power supply rating on the rating plate must comply with mains supply.
Always disconnect the power supply before opening the unit.
15. Maintenance & Cleaning
Always switch off power before starting any work on the unit. Only qualified
personnel may conduct any maintenance work on the cooling unit.
The unit must be removed from the control cabinet for wet cleaning.
Danger to the environment through unauthorized disposal.

14. Repair

12
back to top