End Of Programme; Canceling The Programme - Beko DRZ1025B User Manual

Operating the product
C
Any laundry added after the
drying process has started
may cause the clothes that are
already dried in the machine
intermingle with wet clothes and
the result will be wet laundry
after the drying process is over.
C
You may repeat laundry adding
or removing process as many
times as you desire during
drying. However, this process
will increase the programme
time and energy consumption
since the drying process will
be interrupted repeatedly.
Therefore, it is recommended to
add laundry before the drying
programme has started.
C
If you select a new programme
by turning the Programme
Selection knob while your drier
is in Pause mode, then the
current program is aborted and
new programme information is
displayed.
Do not touch the inner surface of
the drum when adding or taking
out laundry while a programme is
running. Drum surface and dryer
air within is hot.

5.14 Canceling the programme

To cancel the programme after the dryer is
started:
• Press and hold Start / Pause button for
1 seconds to pause the programme and
turn the programme selection knob.
• Press and hold On / Off / Cancel Button
for 3 seconds and the programme will be
cancelled.
A
As the dried laundry will be
excessively hot when you cancel
the programme while the dryer
is running, activate the Refresh
programme to cool them down.
58 / EN

5.15 End of programme

When the programme comes to an end
Lint filter cleaning and Water tank warning
symbols light up in the programme follow-up
indicator. To turn off the dryer press On / Off
/ Cancel button.
C
2-hour Anti-creasing program
will be activated if the laundry is
not taken out after the program
has come to an end.
C
Clean the lint filter after each
drying. See 6.1 Cleaning lint
filter and loading door inner
surface.
C
Drain the water tank after each
drying cycle. See 6.3 Draining
the water tank.
Dryer / User Manual