Advertisement
MODEL: SINGLE SPEED SPIRAL MIXER
MODEL: SINGLE SPEED SPIRAL MIXER
MODEL CODES:
MODEL CODE :DMA1020 R01
DMA3020
Part
Description
No.
1
TOP COVER
2
BOWL CHAIN -TOP
3
BOWL DRIVE SPROCKET - TOP
4
CHAIN
5
BEARING
6
BEARING HUB
7
DOUGH HOOK SHAFT
8
GRID PIVOT
9
MICRO SWITCH
10
STOPPER PIN
11
MAIN ENCLOSURE
12
MIXING BOWL SHAFT
13
GRID
14
SPIRAL DOUGH HOOK
15
DOUGH DIVIDING BAR
16
MIXING BOWL
17
BOWL DRIVEN SPROCKET - TOP
18
V BELT PULLEY - MOTOR
19
TAPER LOCK
20
V BELT A
21
TOP DRIVEN SPROCKET
22
AXEL BEARING
23
AXEL
24
MOTOR
25
BACK COVER
26
CONNECTOR BLOCK
27
TIMER RELAY
28
TIMER
29
GREEN 'START' BUTTON
30
RED 'STOP' BUTTON
31
FASCIA
32
CONTACTOR
33
OVERLOAD
34
BOTTOM DRIVE SPROCKET
35
BOTTOM CHAIN
36
BOTTOM DRIVEN SPROCKET
37
CASTOR WHEEL
38
TOP DRIVE SPROCKET
39
V BELT PULLY - DRIVEN
Page 11
Do not spray water or cleaning products. Liquid could contact the
electrical components and cause a short circuit or an electrical shock.
Do not use equipment if power cord is damaged or has been modified
SAFETY
READ ALL INSTRUCTIONS BEFORE USE. FAILURE TO
FOLLOW THESE PRECAUTIONS COULD RESULT IN INJURY TO
YOURSELF AND OTHERS
1.
When this appliance is to be positioned in close proximity
to a wall, partitions, kitchen furniture, decorative finishes, etc.
it is recommended that they be made of non-combustible mate-
rial. If not, they shall be clad with a suitable non-combustible
heat insulating material, and the closest attention be paid to fire
prevention regulations.
2.
Ensure that the equipment and the power supply cord does not
come into contact with hot surfaces.
3.
Supervision is necessary when the appliance is used in close
proximity to children.
4.
The appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
4.
If the supply cord is damaged, it must be replaced with a new
cord assembly available from the suppliers agent.
5.
Use only earthed outlets matching the serial plate voltage.
6.
Have equipment installed by a qualified personnel in accordance
with local codes and ordinances.
7.
Use equipment in a flat level position.
8.
Do not operate unattended
9.
Do not operate if equipment has been damaged or is malfunc-
tioning in any way.
10. These appliances are designed to run only on alternating current
(A.C.) DO NOT CONNECT TO DIRECT CURRENT (D.C)
WARNING
Electric Shock Hazard.
Keep water and other liquids from entering the inside
of the equipment. Liquid inside the equipment could
cause an electrical shock
Page 4
Advertisement
