Page 1
1. Read this manual carefully. Check the quantity of included hardware to make sure there are no missing parts. If parts are missing or there is any damage to the product, contact your Boutique. 2. The following tools are required (not included with unit): drill, phillips screwdriver, slot screwdriver, allan key, rubber mallet, ruler, pencil.
Page 2
1. Install the base level. 2. Mark drill points using wall jambs as templates. Make sure wall jambs are sitting flush on bottom on base before marking. Pre-drill holes for wall anchors and insert anchors into holes with hammer. 3. Screw wall jambs into wall using #6 Phillips screws. 4.