Operating Basics - Kenwood TK-8180 Instruction Manual

KENWOOD CORPORATION
LCD Display
No. Name
1 Dot Matrix(12digits)
2 Dot Matrix(3digits)
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
TX/BUSY INDICATION
No. Name
1 Red
2 Green
3 Orange

OPERATING BASICS

Switching Power ON/OFF
♦
Press the switch to switch the transceiver ON.
Press and hold the switch for approximately 1 second to switch the transceiver OFF.
Adjusting the Volume
♦
The Volume Up/Down SW control to adjust the volume. You can adjust the volume up sw to increases the volume and
the volume down sw to decreases it.
♦Selecting a Channel
The Channel Up/Down SW to select a channel.
The channel up sw the channel number increases and The channel down sw decreases it.
♦Transmitting
Note: Before transmitting, first monitor the channel to make sure it is not already in use.
1 Select your desired channel.
• If the channel is busy, wait until it becomes free.
1 Press the microphone PTT switch and speak into the microphone. Release
the PTT switch when you have finished speaking.
• For best sound quality at the receiving station, hold the microphone approximately 1.5 inches (3~4cm) from
your mouth.
Alphanumeric display
Channel/GID display
Signal strength indicator
Monitor on display
Talk around display
Scan display
Message stack display
Priority channel 1/2 display
Telephone ID display
Horn alert display
Option board display
Public address display
Zone add display
Auto Recording Display on VGS-1 option
Auto Reply Message Display on VGS-1 option
CH/GID add display
AUX A display
AUX B display
OST display
TX display
Busy display
Call display
ATING
TK-8180-K2 FCC ID:K4437313120
Description
Channel/GID display
Zone display OST list number display
Description
IC:282F-37313120
Zone display