Assembly (continued)
Attaching the ball bearing
3
mechanism and chair frame
□
Place the chair frame (A) face down on
Attach the ball bearing mechanism (E) to
surface.
the chair frame (A) by inserting four hex bolts (AA)
and metal washers (CC).
□
Tighten all the bolts completely by using the hex
wrench (EE).
□
Rotate the 2 plates of the ball bearing mechanism
at a 45 angle. Cover each bolt with the plastic bolt
caps (DD).
NOTE: Each bolt should be tightened a few
revolutions at a time, alternating between bolts in a
cross corner (X) pattern, to ensure your chair is level.
4
Completing the assembly
□
Turn the chair into the upright position.
a flat, soft
7
Please contact 1-855-HD-HAMPTON for further assistance.
HAMPTONBAY.COM