Advertisement

Quick Links

USER MANUAL
IRA-360
Congratulations, you have just acquired a product with JFL Alarmes quality,
produced with the highest manufacturing technology. This manual presents the
main functions and characteristics of the equipment.
www.jfl.com.br

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the IRA-360 and is the answer not in the manual?

Questions and answers

Summary of Contents for JFL Alarmes IRA-360

  • Page 1 USER MANUAL IRA-360 Congratulations, you have just acquired a product with JFL Alarmes quality, produced with the highest manufacturing technology. This manual presents the main functions and characteristics of the equipment. www.jfl.com.br...
  • Page 2 Í NDICE 1 INTRODUCTION..................................3 1.1 GENERAL CHARACTERISTIC............................3 2 MAIN COMPONENTS................................3 3 INSTALLATION..................................4 4 FINE ALIGNMENT..................................5 5 SENSIBILITY....................................5 6 LENS POSITION..................................6 7 SCHEMATIC.....................................6 8 PRECAUTIONS/RECOMMENDATIONS..........................7 www.jfl.com.br...
  • Page 3 INTRODUCTION The IRA-360 is an active infrared sensor. While the TX sensor emits a beam of infrared light the RX is able to receive this signal, the sensor manages and analyzes it through a microcontrolled circuit that compares the transmitted and received signal using information of amplitude, width, and polarity of the signal , and if there is a real intrusion into the protected perimeter it will fire.
  • Page 4 6 - TP1 e TP2: point to measure alignment tension 7 - Power Supply: 10 a 24Vc.c. ou 10 a 24Vc.a.. Figure 2 shows the transmitter sensor and its main components: Figura 2 Transmitter 1 - power supply: 10 a 24Vc.c. ou 10 a 24Vc.a. INSTALLATION After choosing the place to install, follow the steps below: 1-install the transmitter first...
  • Page 5 MIRROR: Always observe both mirrors for a better alignment for both RX and TX. The mirror is used when it´s not possible to view the led ("LD2") on the receiver board. this type of alignment works as a basic alignment being necessary to make a fine alignment. To align see the picture below: Figura 4 FINE ALIGNMENT...
  • Page 6 LENS POSITION Figura 7 SCHEMATIC Figura 8 www.jfl.com.br...
  • Page 7 Do not install near places where it can have splash of mudd or dirty water. IRA-360: - On places with intense fog install in the maximum of 100 meters - Do not install in a movable base or easy dislocation.
  • Page 8 WARRANTY JFL Equipamentos Eletrônico Indústria e Comércio Ltda guarantees this device for a period of 1 (one) year from the date of purchase, against manufacturing defects that prevent its operation within the specified technical characteristics of the product. During the warranty period, JFL will repair (or replace at its own discretion), any component that is defective, excluding the battery that naturally wears out.

Table of Contents