Table of Contents
Advertisement
Verify Component Connector Polarity
The components supplied with your Outdoor Antenna Kit are configured with either
Standard-N connectors or Reverse Polarity-N connectors, subject to the country where
the kit was purchased. Refer to the following table to verify that the polarity of each
connector is correct for your installation.
ETSI Countries, France, Spain, and
Japan
1 - PC Card connector
A
2 - Standard-N Male
B
Standard-N Female on both ends
C
Standard-N Male on both ends
D
Standard-N Female
NOTE
If you wish to purchase individual components, make sure you specify the correct
N-Type connectors to match the configuration that applies to your country.
FCC Countries
1 - PC Card connector
2 - Reverse Polarity-N Female
Reverse Polarity-N Male on both ends
Reverse Polarity-N Female on both ends
Reverse Polarity-N Male
The term Male or Female does not refer to the connector thread,
but to its center pin.
•
Male connectors have a solid center pin.
•
Female connectors have a hollow center pin
Site Preparation Guide
15
Advertisement
Table of Contents
