ZIGBEE YALE-852-Ultra Introduction

YALE-852-Ultra PIR Motion Sensor Camera
Introduction
YALE-852-ULTRA is a ZigBee passive infrared (PIR) motion sensor camera. It is capable of sending
wireless signals and captured images (picture quality of up to 640 x 480 pixels) to the coordinator in the
ZigBee network upon movement detection.
The PIR Camera is designed to give a typical detection range of 12 meters when mounted at 2 meters
above ground. It consists of a two-part design made up by a cover and a base. The cover contains all
the electronics, optics and camera, and the base provides a means of fixing. The base has knockouts to
allow mounting on either a flat surface or in a corner. The PIR Camera also has tamper protections
switch which will be activated upon any attempt of unauthorized cover opening.
The PIR Camera utilizes ZigBee technology for wireless signal transmission. ZigBee is a wireless
communication protocol that is reliable and has low power consumption and high transmission efficiency.
Based on the IEEE802.15.4 standard, ZigBee allows a large amount of devices to be included in a
network and coordinated for data exchange and signal transmission
The PIR Camera serves as an end device in the ZigBee network. It can be included in the ZigBee
network to transmit signal upon activation, but cannot permit any other ZigBee device to join the
network through the PIR.
Parts Identification
1. Blue LED/Function Button
LED Indication:
The Blue LED lights up in the following conditions:
- The Blue LED flash once every 20 minutes
The PIR Camera has lost connection to its current ZigBee
network.
- The Blue LED lights up for 30 seconds:
The PIR Camera is warming up when fault(s) exists in the PIR
Camera.
- The Blue LED flashes twice quickly:
The PIR Camera has successfully joined a ZigBee network
after factory reset.
- The Blue LED lights up for 2 seconds under normal operation:
The PIR Camera has detected a movement when fault(s)
exists in the PIR Camera.
- The Blue LED flashes rapidly
PIR Camera is transmitting pictures to the coordinator of the
ZigBee network when fault(s) exists in the PIR Camera.
- The Blue LED and Flash LED flash once
PIR Camera has been reset.
Function Button Usage:
- Press the button once to send a supervision signal.
- To reset the PIR Camera:
Press and hold the button for 10 seconds. Release the button
when both the Flash LED and the Blue LED flash once
2. IR Sensor
The sensor is intended to detect moving objects.
3. Flash LED
The Flash LED delivers sufficient light for image capture under low
lighting condition.
Both the Flash LED and the Blue LED will flash once when the
Function Button is pressed for 10 seconds to indicate the PIR
Camera has been reset.
1