Advertisement

Quick Links

MODEL 502A
MODEL 502A
MODEL 502A
MODEL 502A
BEAMER
Remote Control Spotlight
Owners Manual
INSTALLATION AND OPERATION
INSTRUCTIONS
IMPORTANT!
READ THESE INSTRUCTIONS BEFORE
INSTALLING OR USING THIS PRODUCT
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.

Advertisement

Table of Contents
loading

Summary of Contents for Guest 502A

  • Page 1 MODEL 502A MODEL 502A MODEL 502A MODEL 502A BEAMER Remote Control Spotlight Owners Manual INSTALLATION AND OPERATION INSTRUCTIONS IMPORTANT! READ THESE INSTRUCTIONS BEFORE INSTALLING OR USING THIS PRODUCT KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
  • Page 2 The penetrating 100-watt beam can illuminate objects up to one (1) mile away. All Guest Beamer spotlights can rotate 355° and move up and down through an 80° arc. Although the model 502A cannot be upgraded for wireless control, multiple control panels can be installed using the 729828-P dual station control.
  • Page 3: Installation

    Installation Installation Installation Installation Mounting the Spotlight 1. Select a horizontal, smooth surface to mount the spotlight on. Be sure you will have access to the underside of the chosen location, and that you will be able to drill holes there without damaging existing wiring or structures.
  • Page 4: Electrical Connections

    Tighten the nuts enough to slightly compress the small gasket. Electrical connections The Guest Model 502A spotlight has two types of wiring connections. They are: Control Cable wires - the small wires within the gray casing that carry your commands from the...
  • Page 5 • Power supply wires- are Black (-) and Red (+) wires without connectors that bring 12-volt DC power into the spotlight and into the control panel. CAUTION! DO NOT CONNECT THE CONTROL WIRES (with connectors) TO ANY POWER SUPPLY WIRES. DO NOT REVERSE THE RED (POSITIVE) AND BLACK (NEGATIVE) POWER WIRES.
  • Page 6: Operation

    Under normal conditions, mild detergent and water will be sufficient to keep the spotlight clean. Avoid using caustic chemicals or abrasives as they may damage the housing. No lubrication is necessary. For replacement parts you can call The Guest Co. at 203-235-4421 or contact your local dealer. Item...
  • Page 7: Troubleshooting

    If your light has a problem that is not described above, return it to the Guest Service Department for a free inspection. Be sure to include a brief description of the problem, and proof of purchase...
  • Page 8: Limited Warranty

    LIMITED WARRANTY For one (1) year from the date of original purchase, The Guest Co. will, at its discretion, repair or replace for the original consumer, free of charge, any parts found defective in material or workmanship. All transportation charges under this warranty must be borne by the consumer.

Table of Contents