Page 1
BluGuitar® AMP1 ™ + REMOTE1 ™ | Programmable Guitar Amp System designed by Thomas Blug ANLEITUNG...
Page 2
If a loop is activated, the signal is sent through the the loop additional features. From choosing preset sounds to programming custom sounds, with the REMOTE1 ™ can do it all! programmable.
Page 3
The volume necessary to achieve this is pressed and turned into compression and light overdrive. If you turn up feature, use a MIDI cable to connect MIDI OUT on the REMOTE1 to your MIDI device's MIDI IN.
Page 4
OPeratiNG The following functions are available when the Direct-Access-Mode is active (the Mode/Store switch is lit): Mode Selection: Preset-Mode offers the ability to combine all of the REMOTE1 ™ control and switching functions available in Direct-Access-Mode into CLEAN, VINTAGE, CLASSIC, MODERN, BOOST, REVERB, FX-LOOP, adjustable 2nd Master Volume and PowerSoak.
Page 5
LOOPerKit Preset eXaMPLes PrOGraMMaBLe aMP1 systeM Master LOOP 4 LOOP 3 LOOP 2 LOOP 1 Multi FX Preset ChaNNeL GaiN BOOst reVerB VOLuMe Preset OVerdriVe ViBe sCreaMer Phaser COMPressOr BOOst FX-Return • • • Perfect for Channel Clean FX-Send Australia ROOM MIDI CHANNEL 2 Input...
Page 6
1.OPEN PANEL 2.REMOVE PANEL 3.INSERT LOOPERKIT ™ 4.FIX LOOPERKIT ™ 5.CONNECT BREAKOUTBOX 1.SET REMOTE1 ™ to DIRECT-ACESS-MODE 2.PRESS & hOLD FX-LOOP 3.SET LOOP 1-4 4.PRESS & hOLD STORE (ALL BLINK) 5.STORE TO PRESET 1-9 REVERB FX LOO P MASTER VOLUME...
Need help?
Do you have a question about the REMOTE1 and is the answer not in the manual?
Questions and answers