Table of Contents
Advertisement
Changing programme default settings
en
Starching
The laundry should not be
Note:
treated with fabric softener.
Liquid starch can be used in all wash
programmes. Pour starch into the
dispenser M according to
manufacturer's specifications
(if required, clean beforehand).
Dyeing/Bleaching
Dye in household quantities only. Salt
may attack stainless steel! Observe
specifications of the dye manufacturer!
Do not bleach laundry in the washer
dryer!
Soaking
Pour soaking agent/detergent into
1.
dispenser II according
to the manufacturer's instructions.
Set the programme selector to
2.
Cottons 60°C and select
Reload.
After approximately 10 minutes
3.
select
Start/Reload to pause the
A
programme.
After the required soaking time,
4.
reselect
Start/Reload if the
A
programme is to be continued or
change the programme.
Load laundry of the same colour.
Note:
No additional detergent is required,
the soaking solution is used for
washing.
24
0
Y ou can change the default settings for
C h a n g i n g p r o g r a m m e d e f a u l t s e t t i n g s
selected programmes. The settings can
be changed even while the selected
programme is running. The effects
depend on the progress of the
programme.
°C Temp.
( The indicated washing temperature
can be changed. The maximum
selectable washing temperature varies
depending on the selected programme.
Start/
A
Overview of programmes ~ Page 20
0 rpm
0 The spin speed can be changed
before and during the programme (in
rpm, revolutions per minute) depending
on the progress of the programme.
Setting - - - - (Rinse stop = without final
drain/spin cycle), laundry remains in the
water after the last rinse cycle.
Setting 0 (Without any spin cycle), drain
the rinsing water only, no spin cycle.
The maximum spin speed depends on
the programme and model.
Overview of programmes~ Page 20
Changing programme
default settings
Advertisement
Table of Contents
