Advertisement
Tips and Tricks . . .
Getting Started - Don't be surprised if your cars stop several times when you first use the
track. Moisture in the air causes corrosion on the steel track rails and it takes a few laps of
running to clean it off. So just give the car a push any time it stops and continue to drive. It
will get better each lap and usually after 3 to 5 laps, the problem goes away completely. This
can happen anytime the track is unused for many days.
Doesn't Line Up? - On very large sets like this it isn't unusual for the track to not line up
perfectly. This is usually caused by little gaps between the track pieces that allow movement
over large areas when you are laying down the track. To avoid this, start laying down track
from the center of the longest straightaway. If the track doesn't come together perfectly,
connect it anyway and the adjust the track by smoothing out the straights and corners a little
bit at each track segment.
SF
U.S. FCC Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Advertisement
