Stealth Glite PRO User Manual

Glite Vario PRO
Start up
1. Insert the Nano-SIMcard and wait for about 10 seconds for the device to bootup
2. Call the unit, and the unit will pick up the call
3. Wait for unit to send replies, sometimes it can take a short amount of time.
4. Close the unit with screwdriver, gently tighten
Commands:  - variable
Activation of VOX
SNDSENS
detection
Movement detection
MOVESENS
Factory settings RESET
Status of device STATUS
Password settings PASSWORD
Turn off LED diodes LEDMSK
Voice during phone
call (Gain)
www.stealthtronic.com | sales@stealthtronic.com
Glite 20 PRO
0 -OFF
1-100 – The lowest sensitivity
0 -OFF
1 - MOST SENSITIVE
100 - the lowest sensitivity
0 – Turn off
001 - 999 – set number
possibility
0 – OFF
15- ON
Glite PRO
The number refl ects the "dB" in the surrounding,
so if you will set it to 30 you will need noise of 30
dB to activate it. Recommend it for activation by
voice is 30-50db
The number refl ects a vibration in a sensor that
needs happen, before the unit is activated.
Factory settings = SLP0, SLPINT15, PWRINT2,
LEDMSK15, MOVESENS0, SNDSENS0
Returns the status of the device, including a
battery
If you decide to activate password you will have to
use it for further communication with the device.
For example, if you set PASSWORD777 and you
will want to change the sensitivity you will need
to do so like this 777SNDSENS50
You will turn off the led diodes by sending to the
device LEDMSK0
Simply, for increasing the signal from the micro-
phone, you use following commands, pressing on
the keypad: #01, #02, to #09 ... wait in between the
pressing of DTMF tone.
user manual