Navigating Between Modes; Cycling Between Timekeeping Mode Digital Display Contents; Shifting The Hands; Solar Charging - Casio MSG-S600 Operation Manual

Navigating Between Modes

Press (C) to cycle between modes.
Holding down (C) for at least four seconds
●
in any mode enters the Timekeeping Mode.
Timekeeping Mode
C
Alarm Mode World Time Mode
C
Countdown Timer Mode Stopwatch Mode
C
Auto-return
While a time or other setting screen is
displayed (digital display flashing), the watch
will exit the setting screen automatically after
about two or three minutes of non-operation.
High-speed Scrolling
In all modes, (B) and (D) are used to change
the currently selected setting. Holding down
(B) or (D) scrolls through settings at high
speed.
Cycling Between
Timekeeping Mode Digital
Display Contents
Each press of (A) in the Timekeeping Mode
cycles display contents as shown below.
Month, day
A
Hour, minute
Watch Operation Guide 5550

Shifting the Hands

Hand shift moves the hands out of the way for
easy viewing of display information.
1.
Hold down (C) for at least two seconds.
Release the button when [HAND] appears
on the display.
This will shift the analog hands to allow
●
easy viewing of display information.
C
2.
Hold down (C) for at least two seconds
again. Release the button when [HAND]
appears on the display.
This returns the hands to their normal
timekeeping positions.
C Note
If you leave the watch with its hands
●
shifted and do not perform any
operation for about one hour, the
hands will resume normal timekeeping
automatically.
The hands will shift automatically
●
whenever you display a setting screen
while in the Timekeeping Mode,
Countdown Timer Mode, or Alarm
Mode. They will automatically return to
their normal timekeeping positions
when you exit the setting screen.
However, if the hands were already
shifted before you displayed the
setting screen, they will remain shifted
when you exit the setting screen.

Solar Charging

This watch runs on power supplied from a
rechargeable (secondary) battery that is
charged by a solar panel. The solar panel is
integrated into the face of the watch, and
power is generated whenever the face is
exposed to light.
Charging the Watch
●
When you are not wearing the watch, put it in
a location where it is exposed to bright light.
While you are wearing the watch, make sure
that its face (solar panel) is not blocked from
light by the sleeve of your clothing. Power
generation efficiency is reduced even when
the face of the watch is blocked only partially.
YES NO
Important!
Depending on light intensity and local
●
conditions, the watch may become hot
to the touch when exposed to light for
charging. Take care to avoid burn
injury after charging. Also, avoid
charging the watch under high-
temperature conditions like the ones
described below.
On the dashboard of a vehicle
ー
parked in the sun
Near an incandescent light bulb or
ー
other source of heat
Under direct sunlight or in other hot
ー
areas for long periods
The display panel may become black
●
under very high temperatures. This is
temporary, and the display will return
to normal at lower temperatures.
6