Removing And Installing Memory Modules - Sony PCG-Z1RAP1 VAIO User Manual

Removing and Installing Memory Modules

Make sure you read the safety information in
When installing a memory module, do not open the module package until you are ready to install it. The package protects
the module from Electrostatic discharge (ESD).
For memory upgrades and information about which memory modules to use, refer to your VAIO
the Welcome page.
To remove a memory module
1. Turn off the computer and all attached devices.
2. Disconnect the power cord, all cables, and remove the battery if it is installed. See "To remove the battery."
3. Wait for the computer to cool down.
The interior of the computer becomes extremely hot during operation. Wait at least one hour for the computer to
cool down before you remove the screws.
4. Turn the computer over and use an appropriate screwdriver to loosen and remove the two screws on the bottom
of the computer.
To avoid damaging the computer, do not remove or loosen any other screws.
Rem ov ing the Bottom Screw(s)
5.
Position the computer so you are looking at the keyboard, and place your fingers behind the last row of keys.
Positioning the Com puter
6.
Gently lift the keyboard up and turn it over the touch pad. Do not detach the cable when lifting the keyboard.
Lifting the Keyboard
Precautions and Procedures before you remove or install a memory module.
Computer Specifications on
®
Page 132