Cross handle 5-hole bath set & pull-out black hand shower with deck diverter trim only,
to suit r1-4006 rough.
lever 5-hole bath set & pull-out black hand shower with cross handle deck diverter - trim only,
to suit r1-4007 rough.
lever 5-hole bath set & (8 pages)
Three handle thermostatic rough with flow control & 2-way diverter, to suit m1-4404 & x1-2013 (11 pages)
Summary of Contents for Lefroy Brooks M1-2201
Page 1
INSTALLATION, OPERATING & MAINTENANCE INSTRUCTIONS M1-2201 LEVER 5-HOLE BATH SET & PULL-OUT BLACK HAND SHOWER WITH DECK DIVERTER TRIM ONLY, TO SUIT R1-4007 ROUGH...
Dimensions in Inches (& Millimetres) 2 11/16" (67.8mm) 3 1/8" 9 15/16" (80mm) (252mm) Ø2 3/8" 2-Ø2 3/8" Ø2 3/8" (Ø60mm) (2-Ø60mm) (Ø60mm) 9 1/16" (230mm) 11 1/4' (286mm) Whilst every effort is made to ensure accuracy, design and dimensions are subject to change without notice as part of the company’s product development process.
Installation Procedure Steps 1-2 Lefroy Brooks always recommends that plumbing products be installed by a licensed professional. Shut off main water supply before installation. Make sure that main water supply is shut off before further installation. Take off all rubber protective caps, plugs from valves, as well as the underneath protective bubble bags Install handles.
Page 5
Installation Procedure Steps 3-4 Lefroy Brooks always recommends that plumbing products be installed by a licensed professional. Shut off main water supply before installation. 1-3/16"(30mm) Important: It is recommended that to prevent the spout from accidentally rotating after installation, where possible, the small brass pin should be screwed into the spout base.
Page 6
Installation Procedure Steps 5-6 Lefroy Brooks always recommends that plumbing products be installed by a licensed professional. Shut off main water supply before installation. Attach hand shower with final trim installation. After installing faucet, remove aerator and open the hot and cold supplies.
Fault Finder Fault Cause Rectification Leaks around the base of spout. Gasket is misfitted or damaged. Check for gasket placement. Aerator leaks or has an inconsistent Aerator is dirty or misfitted. Unscrew the aerator to check rubber water flow pattern. packing or replace the aerator.
Safety Tips, Care and Maintenance Safety Tips If you are soldering during faucet installation,remove cartridges, seats, gaskets and washers prior to applying flame, otherwise you will void the warranty. Cover drain openings to avoid losing small parts. When cutting or soldering pipe, use safety glasses to protect your eyes. Important Points Prior to beginning installation.
Not Covered by this Guarantee Damage or defects arising from incorrect installation, improper use or lack of maintenance. Installed product damaged in transit Consequential loss, damage or product removal and installation costs. Lefroy Brooks is not responsible for any on site labour charges.
Page 11
TELEPHONE: 718-302-5292. FAX: 718-302-4177 The use of trademarks, product design and artwork is subject to licence or agreement with Christo A. Lefroy Brooks. The design registrations, trademark registrations and copyrights are protected by law and the use or reproduction outside the terms of an agreement is prohibited.