Husqvarna VentMaster 570X-Torq Operation Manual page 40

Recommended original and replacement bar and chain combinations
Following is a list of recommended cutting equipment for Husqvarna chain saw models 575XP, 575XPG and 570. These chain saw
models equipped with either of the listed bar and sawchain combinations, fulfills the requirements according to ANSI B 175.1-2000
(Gasoline Powered Chain Saws - Safety Requirements).
Length, inch Pitch, inch
16 3/8
18 3/8
20 3/8
24 3/8
28 3/8
16 3/8
18 3/8
20 3/8
24 3/8
28 3/8
Note: ATM (Armour Tip Medium) is a designation for a hard nose bar with nose radius 1,33".
WARNING! This chain saw is capable of
!
severe kickback that could result in serious
injury to the user. Do not operate this chain
saw unless you have extraordinary cutting
needs and experience and specialized
training for dealing with kickback. Chain
saws with significantly reduced kickback
potential are available.
40 –
English
TECHNICAL DATA
Bar
Gauge, inch Max. nose radius
0,058 11T
0,058
0,058
0,058
0,058
0,050
0,050
0,050
0,050
0,050
Chain
Type Drive link count
Husqvarna H42, 60
Husqvarna H48
68
72
84
92
Husqvarna H46, 60
Husqvarna H47
68
72
84
93