Beko HTV8733XW0 User Manual page 67

Troubleshooting
Foam is overflowing from the detergent drawer.
• Excessive amount of detergent is used. >>>>
water and pour into the main wash compartment of the detergent drawer.
• Put detergent into the machine suitable for the programmes and maximum loads
indicated in the "Programme and consumption table". When you use additional
chemicals (stain removers, bleaches and etc), reduce the amount of detergent.
Laundry remains wet at the end of the programme. (*)
• Excessive foam has occurred and automatic foam absorption system has been
activated due to too much detergent usage. >>>
detergent.
Drying lasts too long.
• Excessive laundry loaded. >>> Do not load the machine in excess.
• Laundry is not spun enough.>>> Spin at a higher spin speed in washing step in the Dryer-
Washing Machine.
• Tap is turned off. >>> Turn on the taps.
Laundry is still damp after drying.
• An appropriate programme according to laundry type might is not selected.>>>Check care
labels on clothes and select an appropriate programme or use timed programmes in
addition.
• Excessive laundry loaded. >>> Do not load the machine in excess.
• Laundry is not spun enough.>>> Spin at a higher spin speed in washing step in the Dryer-
Washing Machine.
Machine does not start or programme cannot be started.
• Power cable is not connected. >>> Make sure the power cable is connected.
• Programme is not set or Start / Pause / Cancel button is not pressed. >>> Make sure the
programme is set and it is not in Stand-by mode.
• Child lock enabled. >>> Disable Child lock.
Laundry is shrunken, pale, matted or damaged.
• An appropriate programme according to laundry type is not selected.>>>Check care labels
on clothes and select an appropriate programme or use timed programmes in addition.
You must not dry clothes that are not suitable for drying.
Machine does not dry.
• Laundry is not dried or drying step is not enabled. >>> Check if drying function is selected
after the selected washing programme.
Loading door cannot be opened.
Your machine's door is not opened for safety reasons.>>>If door locked indicator is still
active on display after drying, machine keeps the loading door locked until it cools for your
safety.
(*) Machine does not switch to spinning step when the laundry is not evenly distributed in
the drum to prevent any damage to the machine and to its surrounding environment. Laundry
should be rearranged and re-spun.
(**) Regular drum cleaning is not applied. >>> Clean the drum regularly. See 6.2
CAUTION
A
If you cannot eliminate the problem although you follow the instructions
in this section, consult your dealer or the Authorised Service Agent.
Never try to repair a nonfunctional product yourself.
67 / EN
Mix 1 tablespoonful softener and ½ L
Use recommended amount of
Washer-Dryer / User's Manual