Remove The Base Assembly For Vesa Mounting - Philips S Series User Manual

2. Setting up the monitor
Resolution notification
This monitor is designed for optimal
performance at its native resolution,
2560 x 1440 @ 60 Hz. When the
monitor is powered on at a different
resolution, an alert is displayed on
screen: Use
2560 x 1440 for best results.
Display of the native resolution alert
can be switched off from Setup in the
OSD (On Screen Display) menu.
Physical Function
Tilt
25°
Warning
• To avoid potential screen damage,
such as panel peeling, ensure that
the monitor does not tilt downward
by more than -5 degrees.
• Do not press the screen while
adjusting the angle of the monitor.
Grasp only the bezel.
-5°
2.3 Remove the Base Assembly
for VESA Mounting
Before you start disassembling the
monitor base, please follow the
instructions below to avoid any possible
damage or injury.
1. Place the monitor face down on a
smooth surface. Pay attention not
to scratch or damage the screen.
2. Use your fingers to loosen the screw
located at the bottom of the base
and remove the base from the
stand.
3. Use a screwdriver to remove the
screws on the arm, and then detach
the arm/stand from the monitor.
9
1
2