How To Clean - Panasonic SR-MVN187 Operating Instructions Manual

HOW TO CLEAN

Inner Lid
Removal
1. Hold and pull off the Inner Lid to remove in the direction of the arrow.
2. Clean with a dishwashing detergent and soft sponge. Wipe off any
moisture on the Inner Lid with soft cloth.
Inner Lid
Inner Lid Seal
Install
1. Press the Inner Lid over the Inner Lid Shaft.
During installation, the smaller side of the Inner Lid Seal should face to
the user with the Outer lid open.
• If the Inner Lid is inserted improperly, the Outer Lid cannot be closed.
Outer Lid Plate
• Clean with a damp cloth.
Body / Outer Lid /
Upper Frame
• Wipe with a damp cloth.
Remark : Clean after every
use.
Pan
Wash with a dishwashing
detergent and soft sponge.
Wipe off any moisture on the
outside.
Thermostat /
Cast Heater
If an object has stuck on the
Thermostat / Cast Heater,
lightly polish it off using fine
sand paper (of about # 600) /
soft steel wool. Then wipe
with a damp cloth.
Dew Collector
• Hold the sides and remove / install
in the direction of the arrows.
• Remove and empty the Dew
Collector after every use.
8
Outer Lid Plate
Inner Lid
Shaft
C oo
k
K ee
p
W ar
m
Accessories
Measuring Cup
Wash with sponge and dishwashing detergent after use.
Steam Cap
Removal
1. Pull off the Steam Cap
to remove it as
shown in the figure.
2. Remove the Valve Holder by turning it
counterclockwise. Wash and wipe with a
damp cloth.
• Do not remove the Rubber Gasket and
the Valve Packing.
Valve
Rubber
Packing
Gasket
3. Wipe the inside of the hole with a damp
cloth.
Hole
• Please wipe it whenever you use it.
• Please do not remove the Steam Cap
when the appliance is in use.
Install
1 Fit the projection on the Steam Cap into
the hollow of the Valve Holder.
2 Turn the Valve Holder clockwise until it
settles properly and the "click" sound
will be heard.
1
2
3 Fit the Steam Cap into
the Outer Lid as shown
in the figure.
3
Rice Scoop Steam Basket