Parts Identification; How To Assemble - Panasonic NI-GWE080 Operating Instructions Manual

Parts identification

Steamer head
Hook
Steamer holder
Hanger
Ironing cloth
Ironing cloth
support rod
Lock button
Power indicator
light
Power button
Water tank
Power base
Power cord
Power plug
Plug type may vary comply with respective country or region
requirement.
08
Steamer head
Nozzle
Steam
Crossbar
selector
Hose
Holder
Shaded area represents
Crossbar
the hand-held area.
Water tank
Close
Water
tank
handle
Telescopic
Power base Hanger
pole
Hose hole
Fixing nut
Telescopic
pole hole

How to assemble

Steam selector
Be sure to assemble the product on a flat and stable floor.
1. Release the lock button on the power base, and insert the
telescopic pole into the telescopic pole hole on the power
base in the correct direction of installation (see the figure
for the direction of the ironing cloth support rod). Then,
press the telescopic pole down to the bottom and push the
lock button to lock.
Be aware of the direction of the ironing cloth support rod
during installation.
Cap
Open
Water inlet
Water tank
2. Loosen the lock button on the telescopic pole, pull upwards
the telescopic pole to the maximum height, and push the
lock button to lock.
3. As shown in the figure, attach
the hanger to the telescopic
pole (at the small end). To do
so, align the telescopic pole
hole at the bottom end of the
hanger with the lower end of
the telescopic pole, And press
the hanger down until a "click"
is heard. Check that the spring
lock at the end of telescopic pole snaps into the small hole
on the wall of telescopic pole hole. Be aware of the
direction of the hanger and the telescopic pole during
Ironing installation.
cloth
4. Stretch the ironing cloth on the
support
hanger and snap the crossbar
rod
at the lower end into the front
end of the ironing cloth support
rod. Then, straighten the ironing
cloth as shown in the figure and
adjust the ironing cloth support
rod to the appropriate height.
5. Install the hose at the hose hole of
power base and then turn the fixing
nut clockwise to tighten until a "click"
sound is heard.
6. Place the steamer head into the
steamer holder on the hanger.
Telescopic
pole hole
Spring
lock
09