Installing The Dla Identification Labels - Waterous AQUIS ULTRAFLOW Installation, Operation And Maintenance Manual

Safety Introduction

Installing the DLA Identification Labels

DLA DLA HMI Display Name HMI Display Name
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Product Overview
|
102 217
Installation Operation
Use the labels provided with the install kit to identify
the DLAs.
Apply the appropriate label to the DLA as you install
it. In the future, use the label to identify the DLA
during setup, service, and maintenance. Use the
table below to match the DLA with the discharge
name on the apparatus.
Note: It is important to properly number each
DLA as this information will be used to
commission and name the discharges in the
ULTRAFLOW software. To facilitate setup,
labeling both the DLA and its associated
circuit breaker is recommended.
Notes Notes
I-2255 L-1222-5
Maintenance