MOBILE-ALERTS MA10660 Quick Reference

Quick reference
MA10660 wind sensor
MOBILE-ALERTS Sensor
This is a sensor for the "MOBILE-ALERTS" system, it
can be used with this system only. To use the sensor
you need a MOBILE-ALERTS gateway.

Quick Setup

Remove the plastic foil from the solar panel (1) on the
sensor. The wind sensor must be installed with the front
of the sensor (the solar panel) facing true South, or the
reported wind direction will not be accurate. Secure the
main unit to the shaft of the mast holder (2). Use the
right-angle adaptor (3) if the wind sensor will be
mounted on a horizontal mast or surface. Fasten the
mast holder to a suitable mast using the two U-bolts,
washers and nuts included. Mount the wind sensor onto
a mast so the wind can reach the sensor unobstructed
from all directions for an accurate reading. The ideal
mast is between 15.75 mm and 33 mm in diameter.
The wind sensor DOES NOT have replaceable
batteries, it consumes solar power and charges the
internal battery pack automatically

Add Sensor

Open the app, dashboard is displayed. Tap "Add new
sensor" and scan the QR code on the base of the wind
sensor. Then set a name for the sensor.