Summary of Contents for Dominator Select DSO-1
- Page 1 Select Sectional Door Opener Select DSO-1 Doc # 160407_00 These instructions are intended for professional garage door Part # 87186 installers. All references are taken from inside looking out. Released 12/11/19...
-
Page 2: Table Of Contents
Dominator Select Instruction Manual Contents 15. Coding a Transmitter 15.1 Storing the Transmitter Code Installation Instructions 15.2 Installation of the Wall Mounted Transmitter 12 1. Installation Safety Warnings! 15.5 Remotely Coding Transmitters 2. Before you Begin 15.3 Erasing All Transmitter Codes 3. -
Page 3: Installation Safety Warnings
Dominator Select Instruction Manual 1. Installation Safety Warnings! This automatic garage door opener is designed and tested to offer safe service provided it is installed and operated in strict accordance with the following safety warnings. Failure to comply with the following instructions may result in death, serious personal injury or property damage. -
Page 4: Before You Begin
Dominator Select Instruction Manual 2. Before you Begin 2.1 Examine the conditions in the garage: a. Look at the ceiling: i. Is it plastered? The opener is mounted to a perforated angle which MUST be securely fastened to a structural support. -
Page 5: Kit Contents
Dominator Select Instruction Manual 4. Kit Contents 1 x SDO drive unit 1 x Door bracket PLUS 1 x Wall mount transmitter 3 x Pin Snap SSP 8 ZNU 31080 2 x Track Bracket 2 x Transmitters 2 x Hex Head screw M8x25... -
Page 6: Fit The Opener
Dominator Select Instruction Manual 6. Fit the Opener 6.1Secure C-Rail to Opener: a. Remove the Opener from the box, taking care of antenna (if fitted). b. Locate and insert the shaft of drive unit into the C-Rail’s sprocket. c. Fix the two track brackets with four (4) M4 x 8 screws supplied in accessory pack. -
Page 7: Perforated Angle
Dominator Select Instruction Manual 8. Perforated Angle (Not supplied) 8.1 Attach Perforated Angle or equivalent a. Measure across the ceiling from the centre point 3177mm (+/- 150mm) to find a supporting beam. b. Create a perforated angle which best suits your site. Use a hack saw to cut the L shape metal strips. Secure the perforated angle to a supporting beam using diagrams shown below. -
Page 8: Optional Safety Beam Kit
Dominator Select Instruction Manual 10. Optional Safety Beam Kit 10.1 Safety Beams The Safety Beam Kit provides additional safety by preventing the door closing when the beam is blocked by a car, child etc. When the Safety Beam Kit is installed the Auto-close feature can be enabled if required. -
Page 9: Setting Limits
Dominator Select Instruction Manual 12. Setting Limits If a tracklock is being installed with the opener, make sure the tracklock plate is not secured in position until limits are set. Refer to tracklock manual. 12.1 Set the Limit Positions and adjust drive speed: When setting the Close limit, ensure the position is when the door makes first contact with the ground. -
Page 10: Safety Testing
Dominator Select Instruction Manual 13. Safety Testing 13.1 Test the Close Cycle CAUTION: Take care when completing a a. Press the OPEN button or transmitter button to open the safety test. Failure to follow this warning door (If the door starts closing, press the transmitter button to can result in serious personal injury stop the door, then press transmitter again to open). -
Page 11: Auto-Close
Dominator Select Instruction Manual 14. Auto-Close Auto-Close mode is a function that automatically closes the door after a pre-set time. Safety beams must be installed in order to run the Auto-Close function. There are two types of Auto-Close available: i. Standard auto-close - the door will Auto-Close after a programmed time. -
Page 12: Coding A Transmitter
Dominator Select Instruction Manual 15. Coding a Transmitter BUTTON 15.1 Storing the Transmitter Code TRANSMITTER The opener can only operated from remote control FUNCTION transmitters that have been programmed into its memory. Up to 8 codes can be stored in the... -
Page 13: Home Owner Safety Warnings
Dominator Select Instruction Manual 16. Home Owner Safety Warnings! This automatic garage door opener is designed and tested to offer safe service provided it is installed and operated in strict accordance with the following safety warnings. Failure to comply with the following instructions may result in death, serious personal injury or property damage. -
Page 14: Opener Safety & Security
Dominator Select Instruction Manual 17. Opener Safety & Security WARNING! When operating manual release (while the door is 17.1 Your Door CAN NOT be used by the opener when: open) the door may fall rapidly due a. There is an external locking device installed. -
Page 15: User Operating Controls
Dominator Select Instruction Manual 19. User Operating Controls Button Function 1. DOWN ARROW (Blue) Closes the door 2. DOWN ARROW LED (Blue) Illuminates when the door is closed and flashes when the door is obstructed on close or stopped. 3. STOP (Red) Stops the door 4. -
Page 16: Troubleshooting
Dominator Select Instruction Manual 20. Troubleshooting Symptom Possible cause Remedy The opener does Garage door in poor condition e.g. Check the door’s operation not work from the springs may be broken transmitter The opener does not have power Plug a device of similar voltage (e.g. a hairdryer) - Page 17 Dominator Select Instruction Manual 20. Troubleshooting Main Light = Service / Warning Indicator: Requirements for a service and user warnings are indicated after operation by the main light repeatable flasing OFF a number of times followed by a pause. The below table identifys the issues and remedies.
-
Page 18: Maintenance
Dominator Select Instruction Manual 21. Maintenance 21.1 Door Maintenance WARNING! Failure to maintain your A poorly maintained door could cause fatal / serious injuries or garage door may void the warranty on damage to property. your garage door opener. • Frequently examine the door, particularly the cables, springs and mountings for signs of wear, damage or imbalance. -
Page 19: Appendix
Dominator Select Instruction Manual 22. Appendix A - Status Indication during Operating Mode. LEDs Light Status Indicates BLUE GREEN YELLOW solid Open DOOR OPEN CLOSED LEDS rapid Open with Autoclose timer running flashing flashing Opening / Obstructed on Open solid... -
Page 20: B - Adjustment Mode Instructions
Dominator Select Instruction Manual B - Adjustment Mode Instructions a. Press the MODE button repetitively until the GEAR LED starts flashing. b. Referring to the table below, select the desired parameter using the OPEN and CLOSE buttons and observing the number of flashes on the GEAR LED. -
Page 21: D - Setting Limits Via Transmitter
Dominator Select Instruction Manual D - Setting Limits via Transmitter a. Switch power on and the BLUE LED on the CLOSE button Button 1 will start to flash to indicate that the opener is ready Button 2 (inch Open) to set the Close travel limit (Set) b. -
Page 22: F - Setting Up Tilt Door
Dominator Select Instruction Manual F - Setting up Tilt Door Prior to limit set up, the opener can be set to J-Type Tilt Profile. This process allows the opener to pre-set to J-Type settings where the limit is not greater than 1500mm. If J-Type is selected, the speed is customised and cannot be changed. -
Page 23: Warranty
• This Warranty is to be read in conjunction with the owner’s copy of the installation instruction manual. • In this warranty, ‘Dominator Representative’ means an entity authorized by Dominator to service Dominator products. Please check the Dominator website for details. - Page 24 PH: 0800 DOMINATOR (366 462) or visit: dominator.co.nz/dealer-locations Prefixed trademarks are the property of B&D Door NZ Ltd. Dominator Garage Doors & Openers is a division of B&D Group Pty Ltd. ABN 25 010 473 971. © 2019 B&D Group Pty Ltd.
Need help?
Do you have a question about the Select DSO-1 and is the answer not in the manual?
Questions and answers