Jonsered CS2186 Workshop Manual page 41

Cleaning and inspection
Clean all parts and check that the fuel pipe is intact.
Assembly
1. If the chainsaw is fitted with hand grip heating, fit the
heating element if it has been removed.
See page 21 and 23.
2. If a new fuel pipe is to be fitted, do as follows:
A Lightly oil in one half of the new fuel pipe.
B Press the oiled part through the hole in the tank
unit. Allow 80-85 mm to protrude on the outside.
See fig. 4.
C Turn the pipe so that it bends upwards. See fig. 4.
D Cut off the angled ends at both ends so that it
protrudes 80-85 mm on the outside.
E Remove the pipe from the tank and fit the fuel filter.
Push on the pipe as far as it will go.
NOTE!
Take care not to damage the fuel pipe and
throttle cable.
3. If the throttle lock has been removed, it should be
refitted before the tank unit and engine unit are
assembled.
See page 16.
4. Lift the engine unit over the tank unit and push the fuel
pipe and throttle cable into their holes in the bottom of
the carburettor space.
5. The vent for the fuel tank is placed on the right-hand
side of the tank. See fig. 6.
When changing the tank vent use screws of the
"self-threading 6 mm" type to pull out the tank vent.
6. Fit the leads on the stop switch.
7. Fit the bolts (H, J and K) on the flywheel side.
See fig. 3. Tighten the bolts to the torque in the service
data, page 10.
8. Fit the bolts (C, D, E and F). See fig. 2. Tighten the
bolts to the torque in the service data, page 12-13.
9. If the chainsaw is fitted with hand grip heating, fit the
lead at C.
10.Fit the fuel pipe (B) on the carburettor. See fig. 7.
11.Insert the throttle cable casing in the attachment and
hook on the throttle cable (A) on the carburettor.
See fig. 7.
12.Fit the cylinder cover, chain and bar.
See the Operator Guide.
TANK UNIT
Fig. 4
Fig. 5
Fig. 6
A
Fig. 7
H
B
English – 39