Page 1
PUNCH & PLAY PUNCHING BAG FOR KIDS - RED MODEL# 8903PP PRODUCT MANUAL - VERSION 4.21.01 FOR AGES: TO BUILD: TOOLS NEEDED: CUSTOMER SERVICE GQBrands.com • CustomerService@GQBrands.com • 1-866-498-5269 • 4401 Samuell Blvd, Ste 150, Mesquite, TX 75149...
KIDS PUNCH & PLAY warnings and product information can be found at: https://www.globalqualitybrands.com/warnings PUNCHING BAG MODEL# 8903PP To register you product please visit: www.globalqualitybrands.com/product-registration or Scan code: If you have an issue with your item, do not return. Please report items that are damaged or missing parts to the manufacturer GQ Brands within three days of delivery.
PROPOSITION 65 THIS PRODUCT CAN POSSIBLY EXPOSE YOU TO CHEMICALS INCLUDING Dl(2-ETHYLHEXYL) PHTHALATE (DEHP). WHICH IS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER AND BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM. FOR MORE INFORMATION GO TO WWW.P65WARNINGS.CA.GOV. Model# 8903PP...
WARNINGS & SAFETY INFORMATION Please read these warnings and the information in this manual in its entirety. Failure to comply with the following instructions may increase the risk of serious injury and/or death: • The owner and supervisors of this product are responsible to •...
PARTS LIST Pump Speed Bag Short Pipe Long Pipe Adjustable Knob Base - Fill with water or sand Top Base Ring Ring with Small Opening Top Cap Base Cap Screw Left Glove Right Glove 15- Pole Connector 14- Wrench MODEL# 8903PP...
Page 6
ASSEMBLY INSTRUCTIONS Steps 1 1. Place both Base Caps (10) at the bottom and top middle areas of the Base (9). Slide the the Long Pipe (4) and secure tightly. 2. Holding the Long pipe onto the base. Flip over and on the bottom of the base, place the Ring with small opening (7) and Screw (11) and tighten with wrench.
Page 7
2. Slide the Short Pipe (3) into the Pole Connector (15) and long pipe (4) and line up the holes. 3. Secure with adjustable knob (5) by selecting desired height and then tightening the adjustable knob clockwise into available hole slots as shown in diagram. MODEL# 8903PP...
Page 8
ASSEMBLY INSTRUCTIONS STEP 3: 1. At the bottom of the hand pump (1) you will find the needle. Screw the needle into the hand pump to inflate the Speed Bag (2) 2. Find the Speed Bag (2) opening on top of it, and inflate with the Hand Pump (1) until the ball is round and safe to punch.
24 hours, so a new batch must be made each day. Thank You Coupon! As a way of saying thank you for purchasing one of our products, here is a 10% OFF coupon for your next purchase at www.PureFun.net Use Code: GQBRANDS10 at Checkout MODEL# 8903PP...
Need help?
Do you have a question about the 8903PP and is the answer not in the manual?
Questions and answers