Advertisement
Installation Guide
WARNING Please read these instructions completely and carefully.
Risk of electrical shock. Disconnect power before servicing or installing product
1
Ensure the inside of your channel letter or sign box is clean and
free of debris. For best illumination
is white (matte finish preferred).
3
Note that LEDs are only cuttable every 3x modules. This is
indicated by a printed red marking on the wire.
Cut only where marked
5
Drill a suitably sized hole out the back of the sign for connection
to DC power supply.
SALES & SUPPORT
02 9517 3222 |
sales@bounceled.com.au
PH
E
www.bounceled.com.au
ensure the inside of the box
2
Using supplied LED layout, remove tape from module and press in
place. For best illumination, install modules two-thirds of the way
towards the back of the box for single sided signs and centralised
for double-sided signs
4
Secure LEDs by gluing modules in place.
6
Connect modules from the sign to power supply, making sure to
not exceed 15 modules per series. Exceeding 15 modules per
series will lead to voltage drop and uneven illumination.
Advertisement
