OZtrail 10000545 Instructions

SWITCH
INFLATION PORT
AIR NOZZLE
1 IMPORTANT
*
This pump is suitable for inflatable/deflatable
items, such as inflatable beds and boats.
*
This pump is not designed for continuous
operation, do not operate it continuously
for more than 15 minutes.
*
The motor overheating may cause internal
damage, if the pump has been continuously
operated for more than 15 minutes, it should
be fully turned off and let to cool
down for 30 minutes.
*
Keep out of the reach of children.
*
Do not obstruct the inflation/deflation port and keep them ventilated at all times.
*
For fast inflation and reduced motor working time, always use the largest,
most suitable sized nozzle.
*
The USB-C cable is only intended for charging, and the pump should not be operated while
the the unit connected to power.
DEFLATION PORT
TYPE C USB CABLE
CHARGING
INDICATOR LIGHT
CHARGING INPUT
INTERFACE
(FIG 1)
INPUT
2 INFLATE ITEMS
Make sure the unit is fully
1.
charged before operation.
2. Connect the aproppriate nozzle for
the inflatable item to the pump.
Pick the largest nozzle that will fit
into the inflation valve in order to
ensure efficient operation.
3. Insert the nozzle into the inflation
valve and turn the pump on.
4. Ensure that there is nothing
obstructing the inflation or
deflation ports on the pump.
5. Once the inflatable item has been
fully inflated, turn the pump off.
3 DEFLATE ITEMS
1. Open the inflation valve
on the item you wish to deflate.
2. Connect the appropriate nozzle to
the deflation port on the pump.
3.
Insert the nozzle into the valve of the
item and switch the pump on.
Note: on certain inflatable items with
small valves, you may need to pinch
the valve in order to open the
internal flap.
4. Make sure that neither ports are
obstructed during the operation
of the pump, as this can lead
to overheating.
Once the item has been deflated,
5.
turn the pump off.
(FIG 3)
(FIG 4)