SCW 74CIM Install Manual

74CIM
Commercial Indoor Motion Sensor for SCW Shield
Indoor Motion Sensor
commercial battery-powered wall mount sensor with an 85
degree detection range.

Features

• 85° detection range with 78 distinct detection zones
• Range up to 40 feet
• Selectable pulse count 2 or 4
• Designed for commercial applications
• 5 year warranty

Enroll

by entering the serial number into the security panel.
Alternatively, the sensor can be enrolled by placing the
panel into enrollment mode, and then pulling the battery
tab or tampering the device.

Install

by screwing two #5 screws through the unit's mounting
knockouts. Use 2 of the 3 mounting knockouts in the center
of the unit's back to mount on a flat wall, or use 2 of the
4 corner knockouts to mount the unit in the corner of a
room. Mount the sensor 5ft to 8 ft (1.5m-2.4m) high. Screw
the #8 screw through the wall tamper knockout into the
wall, ensuring that the wall tamper screw is attached to
something solid. Tighten all screws until snug. Enroll the
sensor using the instructions above. Close the cover and
conduct a walk test. After testing, take the unit out of walk
test mode and close the cover again. Finally, finish threading
the white #4 screw until it is snug.

Mounting Tips

• Avoid direct sunlight
• Avoid facing directly to AC or heating vents
• Avoid vapor or high humidity
• Avoid curtains, screens, etc. from blocking detection
• Do not install outdoors
• Mounting height 5ft-8ft (1.5m-2.4m)
Use the panel's installation guide to verify proper system setup.
alarms when motion is sensed. It is a
I