Advertisement
OWNER & OPERATOR
INSTRUCTION MANUAL
Model No.
TAHP-12-2 TAHP-24-4
TAHP-36-6 TAHP-48-4
TARB-12
TARB-24
TARB-36
TARB-48
TAMG-12
TAMG-24
TAMG-36
TAMG-48
TATG-24
TATG-36
TATG-48
TASP-18S
TASP-18
TAWR-13
TAWR-13-JB
TAWR-16
TAWR-16-JB
THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL GAS EQUIPMENT, WHO SHOULD
PERFORM THE INITIAL FIELD START-UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL.
POST IN A PROMINENT LOCATION THE INSTRUCTIONS TO BE FOLLOWED IN THE EVENT THE SMELL OF GAS IS
DETECTED. THIS INFORMATION CAN BE OBTAINED FROM THE LOCAL GAS SUPPLIER.
IMPORTANT
In the event a gas odor is detected, shut down units at main shutoff valve and contact the local gas company or gas supplier for service.
FOR YOUR SAFETY
Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this or other appliance.
WARNING
Improper installation, adjustment, alteration, service or maintenance can cause property damage, injury or death. Read the installation,
operating and maintenance instructions thoroughly before installing or servicing this equipment.
IMPORTANT SAFETY NOTICE
www.turboairinc.com
For service contact:
German Knife Inc.
1-800-500-3519
www.turboairinc.com
Advertisement
Table of Contents
Related Manuals for radiance TAWR-13
Summary of Contents for radiance TAWR-13
- Page 1 TAMG-48 TATG-24 TATG-36 TATG-48 TASP-18S TASP-18 TAWR-13 TAWR-13-JB TAWR-16 TAWR-16-JB IMPORTANT SAFETY NOTICE THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL GAS EQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD START-UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL.
- Page 2 TABLE OF CONTENTS PAGE INSTALLATION OPERATING INSTRUCTION 4 - 5 MAINTENANCE WARRANTY INFORMATION German Knife Inc 4184 E. Conant St., Long Beach, CA 90808 Phone : 800-500-3519 Fax : 310-900-1066 www.turboairinc.com SHIPPING DAMAGE CLAIM PROCEDURE The equipment is inspected & crated carefully by skilled personnel before leaving factory. The transportation company assumes full responsibility for safe delivery upon acceptance of this equipment if shipment arrives damaged ;...
- Page 3 INSTALLATION UNPACKING : 1. Remove appliance from container. 2. Remove all protective packaging material. 3. Retain container and packaging material until the appliance is operated and found in good condition. 4. Check appliance for any shipping damage. If appliance shows any external or internal damage, promptly inform dealer/distributor where you bought your appliance.
- Page 4 INSTALLATION INSTALLATION : The installation must conform with local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA54, or the Natural Gas and propane Installation Code, CSA B149.1, as applicable, including: 1. The appliance and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of ½...
- Page 5 OPERATING INSTRUCTIONS PRIOR TO LIGHTING, CHECK ALL GAS CONNECTIONS FOR LEAKS !!!!!!! LIGHTING INSTRUCTIONS : • Turn all burner valves to “OFF” position. • Turn on the main gas supply to the unit. • Turn pilot valve(s) adjusting screw counter clockwise, then light standing pilot and adjust the pilot flame to approximately 1/4 inch to 1/2 inch high.
- Page 6 MAINTENANCE CAUTION All cleaning and maintenance should be done when the unit is cool and the gas supply turned off by turning off the manual shutoff valve. At least on weekly basis, the following items must be inspected: • Clean area surrounding the unit of all combustible material, gasoline and other flammable vapors and liquids. •...
- Page 7 Radiance Heavy Duty Microwaves- HD Series (TMW-1200HD, TMW-1800HD) Any part covered under this warranty that is found by German Knife / Radiance to have been defective within the above time period is limited to the repair or replacement, including labor charges, of defective parts or assemblies.
Need help?
Do you have a question about the TAWR-13 and is the answer not in the manual?
Questions and answers