Table of Contents
Advertisement
line to be used as fill line. Installing a third line is the cleanest and easiest way to add fuel.
An alternative fueling set up is a 2-line system with a T-fitting approved for gasoline use.
Be sure to use a filler plug with either a 2 line or 3 line set-up. It is a good idea to add an
extension to the vent line as shown, that goes up and to the rear of the tank. This helps
to avoid draining fuel from the tank when the model is pointed down.
7. Install the throttle servo as far as possible from the engine. Make sure that you get the
carburetor's full range of rotation with your servo travel. If needed, use the included Long
Throttle Arm Extension. Be sure to use a non-metallic linkage through an outer pushrod
tube and a screw lock connector so that the linkage is adjustable. Components for the
non-metallic linkage can be purchased at your local hobby shop.
Advertisement
Table of Contents
