Maintenance; Adjusting The Belt - Proaction BT7020 Instructions For Assembly And Use

your hands as shown in Fig.6 and lift it,
so that the wheels (33) rest on the
floor.
To prevent accidents DO NOT move
the treadmill across uneven floors.

MAINTENANCE.-

Use the bottle of lubricant to lubricate
the inside of the belt in order to keep
your unit in top condition and to ensure
that friction between the belt and the
board Fig.7 is kept to a minimum (due to
different running styles, always apply
more lubrication to the area where you
place your feet during the exercise).
It is advisable to lubricate the base of
the belt between the board and the
band depending on how often it is
used.
<6
>6
Note: This preventive
schedule is only meant for home use.
In aggressive environments, with high
dispersion of particles or with heavy
weight people,
should be increased accordingly.
If the belt starts to slip after lubrication,
then check the tension of the belt. To
tension the belt, take the 6mm Allen
key and with the machine set to 4km/h
turn screws (R & L) one turn in a
clockwise direction.
CAUTION: Using
supplied by manufacturer or lack of
lubrication leads to loss of warranty.
Hours per week
<=7 >7
1 1 month
month
2 1 month
months
maintenance
lubrication frequency
lubricant

ADJUSTING THE BELT.-

If your unit is not seated evenly on the
four contact points, this may cause the
belt (X) to shift sideways. Rigorous
quality control adjusts and checks the
running belt. However, due to weight
differences and individual styles of
running, the belt may be prone to shift
sideways.
If the belt does shift to the left or right,
stop the machine.
BELT OFFSET TO THE RIGHT.-
This procedure is very important.
Follow these steps. In order to adjust
the belt, set the unit in motion at a
speed of 4km/h. If the belt has moved
to the right, turn screw (R) on the right-
hand side of the machine a 1 4 turn
clockwise. Note the position of the belt,
if after one minute the belt is not
completely centred then repeat the
operation. If you see that the belt has
moved too far over to the left then turn
the right screw back slightly in an
anticlockwise direction. Fig.8.
As soon as you have adjusted the belt
you can begin exercising again.
BELT OFFSET TO THE LEFT.-
In the event that the belt has moved to
the left, turn screw (L) on the left-hand
side of the machine a 1 4 turn
clockwise.
Note the position of the belt, if after one
minute the belt is not completely
centred then repeat the operation. If
you see that the belt has moved too far
over to the right then turn the left screw
back slightly
not
direction. Fig.8.
Important: Overtightening of the belt
can lead to a loss of speed on the
17
in an anticlockwise