INSTRUCTIONS FOR OPENING THE BOX WARNING This manual contains informa�on on limita�ons regarding product use and func�on and informa�on on the limita�ons as to liability of the manufacturer. The en�re manual should be carefully read. Please check that you have all the system components as detailed in the kit content.
Page 4
content 1 X Main Unit 100W 1 X External Speaker 100W 1 X Internal Speaker 2 X External Microphones w/Cable 1 X Driver's Single Toggles Switch w/Mic Or 1 X Driver's Pushbu�on (2) w/Mic 1 X Plug-n-Play Cable Harness INSTALLATION MANUAL...
Upon installa�on, only Car's Power supply (12/24Vdc) should be connected to the CARVOX Main Unit; any other wiring should be avoided. Make sure that the INTERVOX units and the fi�ed wires are not obstruc�ng vehicle equipment or vehicle opera�ons. If the wires have to be fed through the metal bulkhead of the vehicle chassis and/or through any other metal shee�ng, make sure that the wiring...
Mounting Instructions: Avoid leaving visible cables in the cabin to maintain the vehicle’s aesthe�cs unaffected. If there are any cables le� disconnected, insulate them with tape; disconnected cables making an undesired contact can cause a malfunc�on. Installation of Main Unit NOTE: DO NOT FIX PERMANENTLY AND/OR CUT THE WIRES TO THE CORRECT LENGTH UNTIL ALL CONNECTIONS HAVE BEEN TESTED AND THE UNIT HAS BEEN TESTED AND ADJUSTED.
External Microphones For op�mal audio quality, the 2 external microphones should be mounted in one of the following covert loca�ons, one on each side of the vehicle. Op�on 1: Moun�ng in the right & le� external mirror wings Op�on 2: Moun�ng in the right &...
External Speaker Loca�on - The external loudspeakers should be installed in front of the vehicle’s engine or in the wheel arch. Moun�ng - Face the opening of the loudspeaker downwards, so that water can run out freely. The loudspeaker should be installed in such a manner that the maximum sound is audible, and the sound is not obstructed.
Tuning Steps Verify that all components are placed, and connectors are connected properly from all end-units to the Main Unit. Verify that Vehicle is switched on (system is powered by the vehicle power supply). Ac�vate the power switch on the dashboard Driver's Control Unit. The Main unit has 'Listen volume' and 'Talk volume' for op�mal audio tuning.
Technical specifications Main Unit Opera�ng Supply Voltage: 12-24VDC Output Power: 100W Power consump�on: Max- 4A/ 8A, Standby mode < 23mA Output Impedance: Between 2–8 Ohms (Normally 4 Ohms) Harmonic distor�on: < 1% Dimensions Electronic Unit (100W): 36x75x110 mm | Net Weight: 0.2 kg Accessories Internal and External Microphone Sensi�vity:...
Page 13
Control Panels Dimensions Luxury car control Panel: 8x35x55 mm Dimensions Emergency car control Panel: 15x22x45 mm Internal and External Speakers External Speaker Power: 100W Dimensions External Speaker: 185x120x160mm | Net Weight: 1.5kg Dimensions Internal Speaker: 30x70x74 mm | Net Weight: 0.3kg INSTALLATION MANUAL...
Warranty INTERVOX (Security Systems 2005) Ltd. LIMITED WARRANTY INTERVOX (Security Systems 2005) Ltd. ("the Manufacturer") warrants its products hereina�er referred to as "the Product" or "Products" to be in conformance with its own plans and specifica�ons and to be free of defects in materials and workmanships under normal use and service for a period of twelve (12) months from the date of shipment by the Manufacturer.
Page 15
The Manufacturer shall not be liable for any damage or loss whatsoever, whether directly, indirectly, incidentally, consequen�ally or otherwise, caused by the malfunc�on of the Product due to products, accessories, or a�achments of others, used in conjunc�on with the Products. The Manufacturer does not represent that its Product may not be compromised and/or circumvented, or that the Product will in all cases provide adequate warning or protec�on.
Need help?
Do you have a question about the CARVOX IE Series and is the answer not in the manual?
Questions and answers