Steamist 9315 Installation & Operating Instructions

Steambath Wi-Fi Option
The mySteamist mobile app is designed to work exclusively with the Steamist Total Sense TSC-450 control version 2.00 and higher.
The mySteamist interface device connects your Total Sense steam spa to your mobile device over your home Wi-Fi network. This
allows you to remotely start/stop the TSC-450's pre-programmed user profiles from your mobile device, and see the actual steam
bath and or shower temperature as the room warms up.
WARNING: The default settings of the mySteamist™ interface device
utilizes an unsecured network during the set-up process. This allows for
the possibility that anyone can connect to, and take control of, your
steam bath. Operating the steam bath for extended periods of time with
the door open can damage the home. Do not connect this device until
you are ready to attach it to your secured home network. Please take
proper precautions to make sure your home network is secured.
Installation:
IMPORTANT: Before installing the Wi-Fi interface make sure the
generator and TSC-450 control are installed and tested for proper
operation.
Find a location to mount the Wi-Fi interface within the range of your
home's router. The interface needs to be connected to the steam
generator with the provided 10' cable. Longer cables are available up to
50'.
1. Secure the interface to a wall or flat surface with the 3 screws
provided.
2. Adjust the antenna to the vertical position
(see Figure 1).
3. Connect the multiconductor control cable to the interface and
route it to the steam generator. (see Figure 1)
4. Turn the power to the generator off and remove the top cover of
the steam generator. Locate a knockout hole on the top left side of
the generator to pass the cable through (see Figure 2).
5. Connect the cable to the generator by plugging into one of the
available jacks on the circuit board inside the generator
(see Figure 2).
6. Secure the cable to the generator with the provided strain relief.
Allow a few extra inches of cable inside the generator. Use
available knockouts (see Figure 2).
7. Replace the generator cover and turn the circuit breaker back on
to the generator.
8. Remove the cover on the Wi-Fi interface by sliding the thumb grip
to unsnap the cover (see Figure 1).
9. Check the lights on the interface. They should be as listed below.
If not refer to the troubleshooting section on page 3. If the lights
are as listed continue with the configuration (see Figure 1).
RS2: On green steady 30 to 60 seconds after connecting
WIFI: Off until programmed
RS1: Blinking yellow
485: Blinking red.
PWR: On red steady
Configuring with your mobile device
(recommended):
Note: This method of configuration can only be done if you router is
broadcasting it's SSID (Network Name).
Compatibility Alert: For Apple iOS 10 (and higher) users ONLY, see
Page 3.
11/16
®
Figure 1 - mySteamist Interface
Antenna
(Must be vertical
for best range)
RS2
RESET
WIFI
RS1
485
PWR
Cover
Cable Connection
Figure 2 - Generator Connection
Knockouts for
Control Cables
- 1 -
Installation & Operating Instructions
Product Number: 9315
Reset
Button
RS2
RESET
WIFI
RS1
485
PWR
Bottom View
Modular
Jacks
Pub. No. 307-C
Lights
RS2
WiFi
RS1
485
PWR