Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Garnet GAE-3030
Summary of Contents for Garnet GAE-3030
- Page 1 Garnet ADSL Ethernet Modem GAE-3030 User’ s Guide Ver. 2.1 Garnet Systems Co., Ltd. All rights reserved. Passing on and copying of this document, use and communication of its contents not permitted without written authorization from Garnet Systems Co., Ltd.
-
Page 2: Table Of Contents
Contents Chapter 1. Overview ------------------------------------------ 1.1 Introduction ------------------------------------------------------ 1.2 Features ----------------------------------------------------------- 1.3 Specifications --------------------------------------------------- Chapter 2. Installation ---------------------------------------- 2.1 Before Installation -------------------------------------------- 2.2 Delivery Check --------------------------------------------------- 2.3 Hard Ware Installation ----------------------------------------- 2.4 Soft Ware Installation ------------------------------------------ 2.5 Ethernet Bridge Configuration ----------------------------- 2.6 Ethernet Router Configuration -----------------------------... -
Page 3: Chapter 1. Overview
Garnet ADSL Modem supports either G.992.1(G. dmt) or Splitterless G.992.2(G.lite) standards via software upgrades. Garnet ADSL Modem is suitable to be installed into PC, with Plug and Play function in Windows95/98. Garnet ADSL Modem supports Windows NT, 2000 as well as Rinux and Macintosh. -
Page 4: Specifications
GARNET GAE -3030 ??Garnet ADSL Modem users can easily monitor with network monitoring program, which enables users to see speed of data streams, supports physical connect and disconnect and diagnose hardware malfunctioning. 1.3 Specifications ??Dimension : 135(L) x 188(W) x 35.5(H) -
Page 5: Chapter 2. Installation
Service Protocols. 2.2.Delivery Check ☞ following materials are provided in the package A. ADSL Ethernet Modem – GAE-3030 B. Power Adapter – 110/240V, 50/60Hz C. Console Cable – DB-9 RS-232 port cable D. RJ45 10base-T Ethernet Cable E. RJ-11 telephone line F. - Page 6 GARNET GAE -3030 ☞ <Figure 1. One example for ADSL Network Configuration> Telephone Garnet ADSL Modem Ethernet arne Internet Telephone Micro filter POTS Micro PSTN EXchange...
-
Page 7: Hardware Installation
GARNET GAE -3030 2.3 HardWare Installation ☞ To install modem into PC, follow below steps. 1. Turn off your computer and all attached peripheral devices (printer, monitor, etc.) and unplug them from the electrical outlet. CAUTION : To avoid risk of electric shock, make sure your computer and all peripheral devices are turned off and unplugged. -
Page 8: Ethernet Bridge Configuration
GARNET GAE -3030 ? G.Lite ? G.dmt This is configured by setting the BUN attribute AdslMode with the following console command: bun set port atm/adslmode=<mode> Where acceptable value of <mode> are, t1413, glite, gdmt. Protocol Configuration for configuring the modem for this mode of operation. -
Page 9: Ipoa Routing
GARNET GAE -3030 PPP Routing Routing using NAT (can be used with either IPoA or PPP) 2.7 IPoA Routing When configured for IPoA, data is routed between Ethernet and Classical IP over ATM (RFC1577). The IPoA data runs over a PVC between the modem and the service provider. -
Page 10: Ppp Routing
GARNET GAE -3030 restart 2.8 PPP Routing When configured for PPP, data is routed between Ethernet and PPP over ATM. The PPP data runs over a PVC between the modem and the service provider. The IP address and PVC need to be defined by the service provider. Since the modem is routing, an IP address needs to be assigned on both modem’s... -
Page 11: Nat
GARNET GAE -3030 restart Enable forwarding between the router interfaces: ip relay all Save the configuration and reboot the system: config save restart 2.9 NAT NAT can be used with IPoA routing or PPP routing. NAT has to be enabled on the router interface towards the service provider. -
Page 12: Updating Npimage
GARNET GAE -3030 serviced, and requests from unknown clients are allowed. The following configuration must be performed for the example: Set up the DHCP configuration dhcpserver config add allow unknown-clients; config add allow bootp; config add subnet 192.168.219.0 netmask 255.255.255.0 config add { config add range 192.168.219.1 192.168.219.99;... -
Page 13: Phy Flash Update
GARNET GAE -3030 If the ATMOS image(s) have been corrupted and the Client Access Device has booted in Recovery Mode, it may be necessary to update both the image and NPimage files. If this is necessary follow the steps in section 2.2.1, copy the NPimage file from the Client Access Device CD to the same... - Page 14 GARNET GAE -3030 The driver will display status information during the update procedure. Once the update is completed turn the board off and then on again for the changes to take effect. If there is an error in the update procedure, try turning the board off and then on again and repeating the update process.
-
Page 15: Vci/Vpi Value Configuration
GARNET GAE -3030 file names instead of the default file file> <PHY flash image file> names. 2.12.2.3 Examples Consider the case where the default file names are used. Run the utility from the same directory the PHY files are located: Example : phycon –d Will use the default file names to generate... -
Page 16: Rfc 1483 (Ppp Over Ethernet) S/W Installation
GARNET GAE -3030 - To check new VCI/VPI value, 0:20:2b:8d:40> bridge device <enter> 2.14 RFC 1483 (PPP over Ethernet) S/W Installation The RFC 1483 doesn’t require Dial-Up Networking installation. You can use a program provided by the Service Provider to connect to the Internet, or provided WinPoET Program as follows. -
Page 17: Chapter 3. Appendix
GARNET GAE -3030 ☞ WinPoET support all Windows 9x, NT and 2000. Chapter 3. Appendix 3.1 Connector Specifications 3.1.1 H1 - RS232 Port RS232 9-pin female D-connector transceiver port. Pin Description Pin Description Data carrier detect Data set ready Transmit data... -
Page 18: Warranty
GAE -3030 3.2 WARRANTY LIMITED WARRANTY Garnet Systems warrants that the product will be free from defects in materials or workmanship for a period of years from the date of purchase. Under this limited warranty, and upon proof of purchase, our obligation is limited to repairing or replacing any product or parts proved to be defective at the inspection. -
Page 19: Regulatory Information
GARNET GAE -3030 3.3 Regulatory Information Federal Communications Commission (FCC) Statements This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to guarantee this device doesn’ t harmfully interfere...
Need help?
Do you have a question about the GAE-3030 and is the answer not in the manual?
Questions and answers