Gigabyte Z370 AORUS Gaming 7 User Manual page 85

B-2: Installation in Intel RST Premium With Intel Optane System Acceleration mode
If the SATA controller has been configured in Intel RST Premium With Intel Optane System Acceleration mode,
please follow the steps below:
Step 1:
After system restarts, go to the BIOS Setup, make sure CSM
Support under the BIOS menu is disabled.
Step 3:
Enter the operating system, launch the Intel
Technology utility from the Start menu, and then enable Intel
Optane Memory on the Intel Optane
™ ®
• An Optane memory cannot be used to accelerate an M.2 PCIe SSD.
™
• If more than one Optane
based boot drive. The other(s) can only be used as data drive(s).
• Do not abruptly remove the Optane
correctly.
• If you want to change/remove the Optane
Technology or Intel(R) Optane Memory application first.
• After enabling the Optane
Step 2:
Go to Peripherals\SATA And RST Configuration and
make sure USE RST Legacy OROM is disabled. If you want
to enable the Optane
connector, set PCIe Storage Dev on Port 17 to RST
Controlled; to enable the Optane
M2A_32G connector, set PCIe Storage Dev on Port 9 to
RST Controlled; to enable the Optane
in the M2P_32G connector, set PCIe Storage Dev on Port
21 to RST Controlled.
Step 4:
Rapid Storage If you install more than one Optane
®
which one you are going to use.
®
Memory screen.
™
Step 5:
Follow the on-screen instruction to continue the installation and then restart
the system when completed.
memory is installed, you can select only one of them to accelerate your SATA-
™
memory. Doing so will cause the operating system to stop functioning
™
memory, you must disable it using the Intel
™
memory, the related BIOS settings will remain even after a BIOS update.
™
- 85 -
memory installed in the M2M_32G
™
memory installed in the
™
memory installed
™
memory, please select
™
Rapid Storage
®
Configuring a RAID Set