Battery Installation And Removal - Scotts LPHT12122S Owner's Manual

UNPACKING
This product requires some assembly.
Carefully remove the product and any accessories from the box.
Make sure that all items listed in the packing list are included.
Inspect the product carefully to make sure no breakage or damage
occurred during shipping.
Do not discard the packing material until you have carefully
inspected and satisfactorily operated the product.
If any parts are damaged or missing, please call 1-800-618-7474 for
assistance.
PACKING LIST

Pole Hedge Trimmer head

Telescopic Pole

Charger and Battery Pack

Blade Cover

Shoulder Strap

Owner's Manual
WARNING: Do not install battery until assembly is complete. Failure
to comply could result in accidental starting and possible serious
personal injury.
WARNING: If any parts are damaged or missing do not operate this
product until the parts are replaced. Failure to heed this warning
could result in serious personal injury.
TO ASSEMBLE THE POLE:
Plug the telescopic pole into the power head as shown below.
Then rotate the locking collar counterclockwise to secure.
ATTACHING THE SHOULDER STRAP
Attach the shoulder strap to the strap bracket. Use the shoulder
strap to help support the trimmer while in use.
ASSEMBLY
PIVOTING THE POWER HEAD
The Pole Hedge Trimmer is equipped with a power head
The power head has a spring-loaded button that allows it to be
locked into four positions within its 135-degree rotation. Before
starting the Pole Trimmer, make sure the power head is locked into
position. Do this by trying to rotate the power head in either
direction. The power head should be locked in position and should
not rotate. To pivot the power head, follow the instructions below.
1. Push the round button (A) located on both sides of the pivot
bracket. The button is spring-loaded, so you will feel some
resistance.
2. Grasp the power head motor housing and rotate the power
head to the preferred position.
3. Release the round button. It should snap back into its seated
position. If it does not, rotate the power head back and forth
slightly until the button snaps back into its seated position. The
power head is now locked into position and ready for use.

BATTERY INSTALLATION AND REMOVAL

Hold the tool and the battery firmly when installing or
removing battery.
Failure to hold the tool and the battery firmly may cause
them to slip from your hands and may result in damage to
the tool and/ or battery and a personal injury.
TO INSTALL (Fig. 1)
Align the ribs of the battery pack with the mounting slots in the pole
saw's battery port. Insert the battery pack until it snaps into position.
TO REMOVE (Fig. 2)
Press the battery-release button; the battery pack will disengage
from the latch. Remove the battery pack from the tool.
5
LPHT12122S
th
at pivots.
A