Electrolux EW6S3R07SI User Manual page 22

22 www.electrolux.com
Make sure that the detergent divider is
inserted properly and does not cause a
blockage when you close the drawer.
11.5 Setting a programme
1. Turn the programme dial to select the
desired washing programme.
The indicator of the Старт/Пауза
button flashes.
2. To change the temperature and/or
the spin speed, touch the related
buttons.
3. If desired, set one or more options by
touching the related buttons. The
related indicators illuminate on the
display and the given information
changes accordingly.
If a selection is not possible
an acoustic signal sounds
and the display shows
11.6 Starting a programme
Touch the Старт/Пауза
start the programme.
The related indicator stops flashing and
stays on.
The programme starts, the door is
locked. The display shows the indicator
.
The drain pump can operate
shortly before the appliance
fills water.
11.7 Starting a programme with
the delay start
1. Touch the Отсрочка старта
repeatedly until the display shows the
desired delay time. On the display the
indicator shows
2. Touch the Старт/Пауза
The appliance door locks and starts the
countdown of the delay start. The display
shows the indicator
When the countdown is completed, the
programme starts automatically.
.
button to
.
button.
.
Cancelling the delay start after
the countdown has started
To cancel the delay start:
1. Touch the Старт/Пауза
pause the appliance. The related
indicator flashes.
2. Touch the Отсрочка старта
button repeatedly until the display
shows
off.
3. Touch the Старт/Пауза
again to start the programme
immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Старт/Пауза
pause the appliance. The related
indicator flashes.
2. Touch the Отсрочка старта
button repeatedly until the display
shows the desired delay time.
3. Touch the Старт/Пауза
again to start the new countdown.
11.8 The SensiCare System
load detection
After touching the Старт/Пауза
button:
1. The SensiCare System starts
estimating the weight of the load to
calculate the real programme
duration. During this phase the Time
button
Manager bars
time digits play a simple animation.
2. After about 15-20 minutes the Time
Manager bars disappear and new
cycle duration is displayed.
The appliance automatically adjusts
the programme duration to the load
to achieve perfect washing results in
the minimum possible time.
and the indicator
placed below the
button to
goes
button
button to
button