Cardinal Gates WI-30 Assembly Instructions

WROUGHT IRON DÉCOR GATE - MODEL WI-30
ASSEMBLY INSTRUCTIONS
A
B
D
C
1
A
C or J
6 "
3
NOTE: THIS SIDE OF GATE HAS
THREE (3) HOLES - ONLY USE TOP AND
BOTTOM HOLES FOR THIS STEP
3.
Insert eye bolts with nut and washer (E)
into top and bottom of hinge side gate
(side with three holes). Be sure nuts are
tight. Do not use middle hole for this step.
5
G
2X
LOOSEN AT TOP AND
BOTTOM OF GATE TO
ADJUST GATE WIDTH
5.
Use Allen wrench (G) to unscrew
set screws on top and bottom of
gate to extend gate. LEAVE
SHIPPING TABS IN PLACE TO NOT
MAR GATE FINISH. You will remove
shipping tabs during final tightening.
OPTION
ONE-WAY
STOP BRACKET
FOR OPENINGS 27" (68cm) - 42.5" (108cm)
G
E
F
1. Install hinge bracket
(A) to wall (stationary
side of gate) using
Phillips screw (C)
beginning 6 " above
floor surface. (Use
ruler on left edge of
this sheet to measure
from floor).
OPTION: Long
screws (J) maybe be
used to attach gate to
stud through dry wall.
E
2X
6
6.
Mount latch assembly (K) to gate using 3/4" bolts with serrated
washers (D). Attach wall mount for latch assembly (H) up
into part (K) that is now secure on gate. Slide gate out to
mark holes for (K) on attaching wall. (*OPTIONAL ONE WAY
BRACKET INSTALLED HERE) Then attach the wall mount of
latch assembly to wall using Phillips head screws (C). Optional
long screws (J) maybe be used to attach gate to stud through
dry wall.
IF GATE IS INSTALLED AT TOP OF STAIRCASE:
Install one-way stop bracket (L) on one side of
wall mount latch to have gate open in only one
direction for maximum safety.
GATE IS RECOMMENDED FOR CHILDREN BETWEEEN 6 AND 24 MONTHS.
H
K
2
C or J
B
4
F
I
4. Hang gate by inserting hinge rod (B), through top
of mounted hinge bracket (A), through upper plastic
shoulder washer (F), through both eye bolts, through
lower plastic shoulder washer (F), and finally through
bottom of hinge bracket. To secure hinge, insert
key ring (I) through hole in end of hinge rod. Gate
can be mounted at angles up to 30 degrees.
D
H
L
OPTION
D
ONE-WAY
STOP BRACKET
I
J
OPTION
ONE-WAY
STOP BRACKET
2. Install second
screw (C) in
top of hinge
bracket
securing it to
the wall.
K
SEE REVERSE
FOR GATE
OPERATION
INSTRUCTIONS
L