Box Parts List ..............8 Hose Assembly Diagram & Parts List ........9 FM20 Plumbing Assembly Diagram & Parts List ....10 FM50 Plumbing Assembly Diagram & Parts List ....11 FM20 Frame Assembly Diagram ........12 FM20 Frame Parts List ............13 FM50 Frame Assembly Diagram ........14 FM50 Frame Parts List ............15...
–––––––––––––––––––––––––––––––––––––––––––––––– Limited Warranty Dramm Corporation warrants to the extent of the purchase price, that the Foamer will be free from defects in materials and workmanship to the original purchaser for a period of six months. Parts subject to wear are not covered under this limited warranty. Defects or damages due to the misuse, non-observance of safety standards, or non-observance of EPA chemical guidelines are not covered under this limited warranty.
Do not over–tighten. AIR FITTING Because there are a number of different air fitting standards available, Dramm foamers do not come with a pre-installed air fitting. The air inlet offers both 1/4” female pipe thread and 3/4” male pipe thread as connection options for your fitting.
OPERATION INSTRUCTIONS Connect air line to foamer. Air required is a minimum of 5 CFM @ 60 psi. More air volume may be required with longer hose lengths. Fill the tank with combination of water and foaming chemical, Follow all chemical manufacturer mixing instructions.
AFTER USE INSTRUCTIONS 1. It is recommended to run a gallon of fresh water through the unit after each use. With the discharge ball valve open run the unit until the gallon of water has gone through the unit and discharged out of the discharge hose.
Need help?
Do you have a question about the FM50 and is the answer not in the manual?
Questions and answers