Page 1
AbbVie Snug Vest For use with CADD-Legacy ® 1400 pump This guide pertains only to the use of the AbbVie Snug Vest. For questions or problems, refer to these Instructions for Use or call support toll free at 1- 844-386-4968.
Page 2
Snug Vest is intended for single-patient use only. The Snug Vest is intended to be an undergarment layer that holds the pump close to the body. The Snug Vest features a central zipper that rises midway up the torso for tube access (see Figure i).
Page 3
Precautions: CAUTION: When putting on the Snug Vest, ensure the pump is resting on a flat surface, and will not fall (see Figure ii). If the pump is not completely secure, it may fall and injure you or damage the pump.
Page 4
CAUTION: If you stand up to put on the vest, be sure the pump is secure so that it does not fall and injure you or cause damage to the pump. a. Confirm that the Snug Vest is correctly oriented with the Pump Pocket on the outside of the Snug Vest (see Figure A).
Page 5
Route the tubing to exit the Snug Vest through the Vest Zipper Opening on the top of the Vest Zipper track (see Figure B). Confirm that the tubing is not kinked. Figure B 2) Insert the pump into the Snug Vest: a.
Page 6
3) Interact with the pump (when needed): a. You can access the pump’s keypad through the Pocket Window (see Figure D). Figure D b. Use the Pull Tab to view or cover the Pocket Window. Note: You may need to unzip the Vest Zipper to view the pump screen and keypad.
Page 7
2) Take off the Snug Vest: a. Unzip the Vest Zipper on the front of the Snug Vest. This will loosen the fit of the Snug Vest and make the Snug Vest easier to remove. b. Remove the Snug Vest over your head.