Advertisement
Fountain Components
Image
Item Description
M-Series Platia
Fountain Small
M-Series Platia
Fountain Middle
M-Series Platia
Fountain Pump
M-Series Platia
Assembly & Installation - A fountain can be diffi cult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Component
Quantity
Item #
FT-161A
Bowl
FT-161B
Bowl
FT-161C
House
Fountain
FT-161D
Large Bowl
Fountain Set-Up:
FT-161 M-Series Platia Fountain
Fountain Information:
• This fountain holds approximately 2.5 gallons of water.
• A fountain cover is not available for this fountain.
• No refi ll device or submersible lights are suggested for this fountain.
Pump Information:
WP450LV - 120 GPH Low Voltage Pump (16 ft. cord length)
Tools Required:
Bubble Level
Screwdriver
Scissors
Image
1
1
1
1
Assembly Instructions
Pump Kit Parts List
Component
PK120-LV pump with Transformer
#10 Stopper
2.5" length of PermaGum Putty
Approx. 6" length of 1/2" black
non-kink tubing
1" length of 5/8" clear tubing
Adhesive Dots
Hose Clamps
Proudly
MADE IN USA
Quantity
1
1
1
1
1
4
1
rev 3/30/2020
Advertisement
Table of Contents
Related Manuals for Campania FT-161 M Series
Summary of Contents for Campania FT-161 M Series
- Page 1 FT-161 M-Series Platia Fountain Assembly Instructions Fountain Information: • This fountain holds approximately 2.5 gallons of water. • A fountain cover is not available for this fountain. • No refi ll device or submersible lights are suggested for this fountain. Pump Information: WP450LV - 120 GPH Low Voltage Pump (16 ft.
- Page 2 FT-161 M-Series Platia Fountain Assembly Instructions Assemble your fountain on a level surface capable of holding a minimum of 67 lbs with an approximate 1/4 sq. ft. footprint (actual dimensions 7" Diam). Step 1 - Place the adhesive dots provided evenly around the bottom of the basin (FT-161D) to prevent scratching anything beneath the fountain.
- Page 3 Maintenance: Pump Care - The fountain relies heavily on the quality of the pump. A well-maintained pump can last several years. Step 1 - Fully submerge: Ensure the pump is fully submerged at all times to avoid damage. Step 2 - E nsure water level is sufficient: Check water levels regularly as water may evaporate over time, and periodically change water to avoid algae buildup.
Need help?
Do you have a question about the FT-161 M Series and is the answer not in the manual?
Questions and answers