Lpt Port - Acer TravelMate 2350 Service Manual

LPT Port

Configure the system's parallel port using options: Disabled and Enabled.
Insyde Software SCU
Main
Infrared
Parallel Port (LPT)
£ Legacy USB
<Tab> <Right> <Left> fo r block select.
< Enter> for accept. <Cancel> <Esc> for reject. <Alt> activates accelerators.
<Space> for Enable or Disable.
The table below describes the parameters in the screen. Settings in boldface are the default and suggested
parameter settings.
Port Definition
Port Address
Mode Setting
Chapter 2
Advanced
\
-----------------
-----Port Address-------
Port (FIR)
(
( £» ) LPT1, 378, IRQ7
(
(
Support
Description
Sets the mode for the parallel port.
Standard AT: Normal mode (AT compatible)
Bi-directional: Bi-directional mod (PS/2
compatible)
Enhanced Parallel (EPP): EPP mode
Extended Capabilities (ECP): ECP mode
(requires DMA channel)
Sets the base I/O address for the parallel port.
When Mode is selected as EPP mode, "3BC" will
not be available.
If ECP mode has been selected, then DMA
default is DMA1.
Security Boot
Parallel Port (LPT)
) None
) LPT2, 278, IRQ5
) LPT3, 3BC, IRQ7
EPP Type:
OK
<Up> <Down> for item select.
May 20, 2003 5:40:09
Exit
------------------------------
---Port Definition-----
( ) Standard AT (Centronics)
( ) Bidirectional (PS-2)
£»
( ) Enhanced Parallel (EPP)
( ) Extended Capabilities
(ECP)
-DMA Setting For ECP Mode-
( ) DMA1
£»
( ) DMA3
EPP 1.7
Cancel
Option
Standard AT (Centronics),
Bidirectional (PS-2),
Enhanced Parallel (EPP),
Extended Capabilities
LPT1, 378, IRQ7
None/
278, IRQ5/ LPT3, 3BC, IRQ7
DMA1, DAM3
AM
/ LPT2,
33