Advertisement
Fireplaces
MODEL
OFP-36LED | OFP-42LED | OFP-50LED | OFP-60LED | OFP-72LED
PARTS AND HARDWARE
Suggested Tools
• Phillip head screw driver
• Tape measure
• Power drill
• Drill bit
Parts and Hardware
Fireplace Assembly x 1
Replace the faux fire log set with glass particles:
glass particles
INSTALLATION GUIDE
* Please take out the foam that is inside the unit before using the heater.
1. Remove the outer glass around the bracket, mounting screws
(see 1, 2, 3 of the picture on the right)
2. Remove the outer glass (see 4 of picture on the right)
3. Take out the foam
4. Install the outer glass to the appliance:
Lift glass panel and line up with the top bracket, fasten panel
to the appliance. Screw the brackets to appliance with
mounting screws (see 1, 2, 3 of the picture on the right)
5. Be cautious about the outer glass bracket screws
info@ortechindustries.com
www.ortechindustries.com
NOTE
• Unit needs to be hung on wall stud for more security and stability
• ASSEMBLY TOOL REQUIRED — Phillips Screwdriver
Steel Holder x1
Remove the glass pane, then replace
the faux fire log set with glass particles.
13376 Comber Way
Surrey BC V3W 5V9
Remote Control x1
Maintenance and Cleaning
Before using, wipe with a clean, dry cloth.
Avoid rubbing or scratching the surface
with rough or abrasive objects.
Tools List
• Drill bit
• Drill
• Tape measure
• Pencil
foam
375 Admiral Blvd
Mississauga
,
ON L5T 2N1
Instruction Manual
4mm (W) x 40mm (L)
Screw x 8
1-888-543-6473
1-888-541-6474
Advertisement
