Maintenance And Service Safety Instructions And Practices - Bush Hog RMB 1660 Operator's Manual

Do not let the Blades turn when the Mower Deck is raised for any
reason, including clearance or for turning. Raising the Mower deck
exposes the Cutting Blades which creates a potentially serious hazard
and could cause serious injury or even death from objects thrown from
the Blades.

Maintenance and Service Safety Instructions and Practices

Make sure the PTO shield, integral driveline shields, and input shields
are installed when using PTO-driven equipment.
shield if it is damaged or missing.
Always disconnect the main PTO Driveline from the Tractor before performing service on
the Implement. Never work on the Implement with the tractor PTO driveline connected and
running. Rotating Parts, Blades or Drivelines could turn without warning and cause
immediate entanglement, injury or death.
Never interfere with factory-set hydraulic calibrations.
cause a failure of the equipment and may result in injury.
Relieve hydraulic pressure prior to doing any maintenance or repair work on the Implement.
Place the Mower Head on the ground or securely supported on blocks or stands, disengage
the PTO, and turn off the engine. Push and pull the control Levers or Joystick several times
to relieve pressure prior to starting any maintenance or repair work.
All Safety Shields, Guards and Safety devices including (but not
limited to) - the Deflectors, Chain Guards, Steel Guards,
Gearbox Shields, PTO integral shields , and Retractable Door
Shields should be used and maintained in good working condition. All safety
devices should be inspected carefully at least daily for missing or broken
components. Missing, broken, or worn items must be replaced at once to reduce
the possibility of injury or death from thrown objects, entanglement, or blade
contact.
(SBM-18)
DO NOT allow any person under a raised boom or mower head unless
it is securely locked up or supported.
Implement unless the Tractor is turned off and all motion has ceased.
Never work under the frame work, or any lifted component unless the implement is
securely supported or blocked up. Inadvertent contact with the controls could allow a
component to fall. A sudden or inadvertent fall by any of these components could cause
serious injury or even death.
RMB 1660 11/10
© 2010 Alamo Group Inc.
SAFETY
(SRM-07)
(S3PT-8)
(SBM-22)
Safety Section 1-12
Always replace any
(S3PT-11)
Any change in calibration could
(SBH-13)
DO NOT approach the
(SBM-6)