Page 1
Model : RDR-HF-BTDISP1 FCC # : A4O-EBTR01 Introduction The INFOCHIP Reader is a portable battery powered High Frequency Short Range RFID Reader. It has an integrated display to show RFID Serial number immediately after scanning. Operation Press and release the Button to start scanning. The Reader will scan for 10 seconds. Point Reader antenna directly and near RFID chip to scan.
Page 2
Advanced Menu To enter the advanced menu, first enter the main menu as above and then hold the button down for 8 seconds. You must be on the screen as shown above that displays INFOCHIP 0.00. After entering the advanced menu the screen will display something similar to: fw=0.00 b=01...
Page 3
The unit is designed to operate over the temperature range of -20 to +60 degrees Celsius. Warnings CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS. Copyright 2011 INFOCHIP Page 3 of 4 Rev 03...
Page 4
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. Copyright 2011 INFOCHIP Page 4 of 4 Rev 03...